Basic elements of flashbutt welding, Mechanical Engineering

Basic elements of flashbutt welding

A flash butt welding machine is mainly comprised of a

  1. Main frame
  2. Stationary Platen
  3. Moving Platen
  4. Clamping mechanism
  5. Transformer
  6. Tap switch
  7. Electrical controls
  8. Flashing and upsetting mechanisms.


Platens are usually of cast or fabricated steel and some small machines have bronze, cast iron or copper platens.

Posted Date: 9/17/2012 6:11:56 AM | Location : United States







Related Discussions:- Basic elements of flashbutt welding, Assignment Help, Ask Question on Basic elements of flashbutt welding, Get Answer, Expert's Help, Basic elements of flashbutt welding Discussions

Write discussion on Basic elements of flashbutt welding
Your posts are moderated
Related Questions
Dou you have someone with good GD & T knowledge who can help me with ceheck, markup and comment mechanical drawings in PDF file format wich I will send?

Describe the key terms i. Write two differences between boiler and turbine. ii. Compare the rankine cycle with carnot cycle in terms of efficiency and work ratio iii.

Clutch cable model: Ensure the cables fitted are of the respective model and not interchanged with other model. Also ensure that the cable is genuine.

Initial tension in the belt: Sol: The tension in belt which is passing over the two pulleys (that is driver and follower) when the pulleys are stationary is an initial tensi

1. The linkage system below consists of two bars A & B plus 4 linkages. Each linkage has a square cross section. The allowable tensile strength of all members is 200 MPa, the allow

A helical compression spring prepared of oil tempered carbon steel is subjected to a load which lies between 400N to 1000N. The spring index is 6 and the design factor of safety is

advantages and disadvantages of hot working

The Winged-Edge Representation Perhaps the oldest data structure for a b-rep is Baumgart's winged-edge data structure. It is quite different from that of a wire-frame model, be

CAPP for Machining Process This explained mainly two different approaches to Computer Aided Process Planning, i.e.  (a) Variant approach, and  (b) Generative approach.

Desgin of furnce - combustion chamber: • Deside on type of furnace :need review of furnace types (grete,fluidized bed,puluerised coal or other. • Sectch of furnace design with