Axis perpendicular to the vertical plane - tetrahedron, Mechanical Engineering

Axis perpendicular to the vertical plane - tetrahedron:

A tetrahedron of side 60 millimeter has its base parallel to the VP, along with an edge of the base inclined at 45o to the HP. However the corner contained via such edge is on the HP. Sketch its projections.

Solution

 Construction procedure is given as:

(a) Sketch a line at 45o to xy in VP, and complete the elevation a′ b′ c′ or along with point c′ in xy Mark centre ′.

(b) Sketch line abc parallel to xy representing the base in elevation.

(c) For mark point O in plan, rotate o′ a′ in elevation to o′ to o′a′1 parallel to xy.

(d) Situate a1 along extension line of abc and mark o as or a1 o equal to 60 millimeter along axis.

(e) Connect oa1, ob1, oc1 is like dotted line to finish the plan.

Posted Date: 2/4/2013 12:45:10 AM | Location : United States







Related Discussions:- Axis perpendicular to the vertical plane - tetrahedron, Assignment Help, Ask Question on Axis perpendicular to the vertical plane - tetrahedron, Get Answer, Expert's Help, Axis perpendicular to the vertical plane - tetrahedron Discussions

Write discussion on Axis perpendicular to the vertical plane - tetrahedron
Your posts are moderated
Related Questions
Isolated and Combined Footings Individual columns are generally supported on isolated footings. A typical isolated footing is shown in Figure. This arrangement is suitable when

Explain modified Rankine cycle in detail with T-S and p-v diagrams. Explain Carnot cycle in detail with P-V and T-S diagram, and also write down expression for work ratio, therm

define drawing

Define the process of STEP community The STEP community is in the process of defining and standardizing a number of domain-specific (mechanical or electrical) Application Proto

Design a soda vending machine that can deliver three kinds of soda, A, B and C. All the three soda cost the same amount - 70 cents. The vending machine has four coin slots, one eac

If Taylor's tool life constants for a provided operation are specified of n = 0.5 and c = 400, what is the percentage increase in tool life when the cutting speed is reduced by hal

applications of dynamically induced emf

Q. Identification of Pressure Welds? Pressure welds shall be identified as follows: a. Generally each weld shall be stamped adjacent to the weld with the welder's identity c

Chassis Lubrication System : This lubrication system consists of outer body parts, which are lubricated from outside of the body. Table of Lubrication Points Sl.

WHO IS HOME MINISTER OF INDIA OF 2014?