Axis perpendicular to the vertical plane - square prism, Mechanical Engineering

Axis Perpendicular to the Vertical Plane - square prism:

Here a square prism, side of base 40 millimeter and axis 60 millimeter long is resting on the HP on its base along with one edge inclined at 30o to the VP. Draw its projections.

Solution

Construction procedure is given as:

(a)   Draw a line at 30o to xy and draw the plan that is a square of 40 millimeter side and mark corners like a, b, c and d.

1132_Axis Perpendicular to the Vertical Plan1.png

b) Project the point a, b, c and d upon the reference line xy meeting it at a′, b′, c′ and d′.

(c) Sketch the axis and mark 60 millimeter from xy along the axis or like height of prism.

(d) Sketch a horizontal line parallel to xy and 60 millimeter from it.

(e) Sketch projectors from a, b, c and d and mark 1′, 2′, 3′ and 4′ upon it.

(f) Connect 1′ a′, 2′ b′, 3′ c′ and 4′ d′ as dotted line to complete the elevation.

(g) Darken the optical edges in the elevation.

Posted Date: 2/4/2013 12:42:27 AM | Location : United States







Related Discussions:- Axis perpendicular to the vertical plane - square prism, Assignment Help, Ask Question on Axis perpendicular to the vertical plane - square prism, Get Answer, Expert's Help, Axis perpendicular to the vertical plane - square prism Discussions

Write discussion on Axis perpendicular to the vertical plane - square prism
Your posts are moderated
Related Questions
Isentropic flow through the nozzle: In an isentropic flow through the nozzle, air flows at rate of 600Kg/hr. At inlet to the nozzle, the pressure is 2Mpa and temperature is 1

Create Visual Basic function ffactor(Re, rr) that calculates the Darcy-Weisbach friction factor in a pipe or duct, where Re is the Reynolds No. and rr is the relative roughness, us

1.  Given the data below, design IA-32 instructions to copy data in array X to array Y.   .data X   sdword   10,30,40,-10,-20,-4,-50 Y   sdword   7 dup (?)    2.  Given

Determine the forces in strings: The Electric light fixture weighing 15N hangs from point C , by two strings AC and BC . AC is inclined at 60° to the horizontal and BC

Third Service and Fourth Service Prepare a list and explain the mandatory checks to be carried out during third and fourth service of a motorcycle.

Voltage: The voltage is the potential difference between two points. The current flows from higher potential to lower potential. Voltage is measured in volts (V). V = IR

Calculate the Length of Developed Blank Part shown in Figure is to be produced from flat sheet by bending operation. Calculate the length of the developed blank. Assume k = 0.

for a 210 MW unit how we calculate power output at each stage if the turbine has 25 reaction stages

Q. Show Experimental Verification of time Dilation ? Time dilation is a real effect, it can be verified by making this experiment. (Are created at high attitudes in the earth a

need help to calculate how much a base must weigh to keep a object on to stable when a force is applied from the side