Invalidation of certificate of airworthiness, Other Engineering

INVALIDATION OF CERTIFICATE OF AIRWORTHINESS

Listed below are the four major reasons why a Certificate of Airworthiness could become invalid. There may be other specific reasons, but the majority will come under one or other of these categories.

1. If the aircraft or such of its equipment necessary for airworthiness is overhauled, repaired or modified in a manner not approved by the C.A.A.

2. If any part of the aircraft or equipment is removed or replaced in a manner or with material not approved.

3. Until completion of any inspection classified by the C.A.A. as mandatory.

4. Until completion of an inspection required by an approved maintenance schedule.

The inspections and modifications referred to above are those required for the purpose of ascertaining and ensuring that an aircraft remains airworthy.

 

Posted Date: 9/14/2012 2:02:22 AM | Location : United States







Related Discussions:- Invalidation of certificate of airworthiness, Assignment Help, Ask Question on Invalidation of certificate of airworthiness, Get Answer, Expert's Help, Invalidation of certificate of airworthiness Discussions

Write discussion on Invalidation of certificate of airworthiness
Your posts are moderated
Related Questions
Distinguish between passive and active attacks,

List the advantages disadvantages and applications of FEM?

The energy release rate, often denoted by G, is the amount of energy per unit area that is supplied by the elastic energy in the body and loading system in creating a new fracture

Question: (a) Spreading the spectrum for signal transmission helps alleviate the narrow band interference problem. What is narrow band interference? State and describe 2 differ

can you help me in my assignment in Engineering project and operation management course??


Expertsmind.com brings you unique solution in physics -          What is light? -            -          Light is an electromagnetic wave that also comes in "photons"

a rectangular beam of size 40mm*60mm is subjected to bending. the maximum bending stress is limited to 75N/mm^2. find the moment of resistance of beam section.

If the light source in figure 12.1 (see figure below) of the Warren Smith text is replaced by a 100W light bulb, and the lens aperture is 20cm, what would the 1cm detector at point

Design a sewer collection system incorporating flow rates, pipe sizes and pipe slopes for the proposed residential development shown in the attached drawing. In your design, locat