Atomic hydrogen welding, Mechanical Engineering

Atomic Hydrogen Welding


In this process, an arc is struck between two tungsten electrodes using AC power supply.The Streams of hydrogen gas are passed from orifices around the electrodes into the arc. Here the molecules of hydrogen dissociate into atoms at a point a few millimetres away from the arc and liberate intense heat, which melts the base metal. The hydrogen gas acts as a heat carrier. Filler metal may or may not be used. Till date this process is obsolete.

Posted Date: 9/13/2012 8:08:46 AM | Location : United States







Related Discussions:- Atomic hydrogen welding, Assignment Help, Ask Question on Atomic hydrogen welding, Get Answer, Expert's Help, Atomic hydrogen welding Discussions

Write discussion on Atomic hydrogen welding
Your posts are moderated
Related Questions
A simple Rankine cycle works between pressures 28 bar and 0.06 bar, the initial condition of steam being dry saturated. Determine the cycle efficiency, work ratio and specific st

Motor shall operate successfully at rated load with a voltage variation of plus or minus ten percent and frequency variation of plus or minus five percent, or combined variation of

Find out the axial moment of inertia: Find out the axial moment of inertia of a rectangular area of base b and height d around centroidal axis GX and the base B 1 B 2 . So

Q. Show the support locations for truckable skid? Unless instructed otherwise by Engineer, support locations for truckable skid shall be determined by skid Vendor. Support loca

Ask question EMC#Minimum 100 words accepted#

Carbon Dioxide (CO 2 ) Lasers   The CO 2 laser is a gas discharge device and it operates by electric excitation of an active medium that is a mixture of helium, nitrogen an

Martempering: The piece to be hardened is wholly austenitized and after that quenched in a lead of salt bath held at a temperature simply above at that martensite would begin

(a) What could be the characteristics of tool materials. (b) Describe several tool materials with their composition.


This section shall apply to the general requirements for design, fabrication, erection, and testing of structural steels for supports, stairways, ladders and platforms. All stru