Applications of seam welding, Mechanical Engineering

Applications of seam welding

Lap seam welding is used for the manufacture of cans, buckets and water tanks and for welding thin walled large diameter pipes.

Mash seam welding Is used in barrels, fridge and cabinets where flash butt welding appearance Is required. Foil butt welding is used for large panels. Resistance butt welding is used for large panels. Resistance butt welding is employed for making ERW tubes. Here, the shunting effect is taken care of by high frequency heating.

High frequency seam welding is suitable for finned tubes and other tubings.

Posted Date: 9/17/2012 3:37:20 AM | Location : United States







Related Discussions:- Applications of seam welding, Assignment Help, Ask Question on Applications of seam welding, Get Answer, Expert's Help, Applications of seam welding Discussions

Write discussion on Applications of seam welding
Your posts are moderated
Related Questions
Choose a wire rope for a vertical mine hoist to lift a load of 55 kN from a depth of 300 metres. A rope speed of 500 metres/min is to be attained in 10 seconds.

A smooth sphere of radius 15 cm and weight 2 N is supported in contact with a smooth vertical wall by a string whose length simlar the radius of sphere. The string joins a point on

A light cantilever of rectangular section (5cm deep and 2.5 cm wide) has a mass fixed at its free end. Find the ratio of frequency of free lateral vibration in vertical plane to th

the movability of 3 bar mechanism is zero then how can we comment on instantaneous centre of it?


Find speed for two hours with HSS tools Find speed for two hours tool life for dry machining of free cutting mild steel with HSS tool. Solution From Table 3, a value o

An open belt connects two flat pulleys. The pulley diameters are 300 mm and 450 mm and the corresponding angles of Cap are 160 o and 210 o . The smaller pulley runs at 200 r.p.

What are wall footings? Explain in short. Generally wall footings are required to support direct concentric loads. However, an exception is the wall footings for retaining wall

how to prevent absolute noise during meshing of gears

Motion of two bodies - Smooth surface and smooth pulley: THE HORIZONTAL SURFACE IS SMOOTH AND STRING IS PASSING OVER SMOOTH PULLEY: Figure shows two weights W 1 and W 2 c