Airport lighting, Civil Engineering

Airport Lighting:

Lighting of Approach to Runway

A good system of identification of the runway when landing is to provide six transverse cross-bars of lights placed at right angles to the centre line of the runway, spaced at 150 m, extending to 900 m from the runway end. A visual approach slope indicator (VASI) facilitates the pilot to approach at the correct height.

Runway Lighting

The centre line and edges of the runway are provided with lights. The spacing is 15 m for the centre line and 60 m for the edge lines.

Lighting of Taxiways

The taxiways are lighted similar to runways.

Apron Lighting

Apron lighting is provided by means of high masts.

Posted Date: 1/23/2013 1:45:07 AM | Location : United States

Related Discussions:- Airport lighting, Assignment Help, Ask Question on Airport lighting, Get Answer, Expert's Help, Airport lighting Discussions

Write discussion on Airport lighting
Your posts are moderated
Related Questions
Describe the process of yielding and state the effect work hardening has on the yield point of mild steel using suitable sketches where appropriate.

Radial flow pumps for small flows and high heads In radial flow pumps, a diffuser/volute is generally designed at it outlet to convert the kinetic energy obtained during the pu

design a 3-meter cantilever slab to carry a uniform total dead load of 8.2KN/m^2 and a concentrated live load at the free end of 30 KN/m. f''c=28Mpa fy=420Mpa.

describe setting out right angle at given point on a chain line and when the point lies outside the chain line

random rubble coursed, suare rubble coursed and uncoursed, polygonal walling, flint walling

explain the steps to analyse a portal frame with sway condition

Actually, drying is not directly linked to hardness in concrete. After concrete is poured, putting it in a wet environment by spraying it constantly with water will hasten its hard

Resultant force at a section We can determine stresses at top and bottom fibres, at a section of a beam, due to pre-stressing force and external loads. Using them, we can draw

A shaft 9 m long is subjected to a torque 30 t-m at a point 3 m distant from either end. The reactive torque at the nearer end will be?

I want to ask about mathcad prime 2.0, when I want to save my work it shows that I can''t save it because Excel is busy ,, what I have to do to fix this problem ??