Airflow through divergent and convergent ducts, Other Engineering

 

DIVERGENT DUCT
A divergent duct widens out as the airflow progresses through it. At subsonic speeds the effect of this kind of duct is to decrease the velocity and increase the pressure and temperature of the air passing through it.

143_divergent and convergent ducts.png

CONVERGENT DUCT
A convergent duct is such that the space inside reduces as the airflow progresses through it. At subsonic speeds the effect of this kind of duct is to increase the velocity and decreases the pressure and temperature of the air passing through it.

2137_divergent and convergent ducts1.png

Posted Date: 9/11/2012 7:19:20 AM | Location : United States







Related Discussions:- Airflow through divergent and convergent ducts, Assignment Help, Ask Question on Airflow through divergent and convergent ducts, Get Answer, Expert's Help, Airflow through divergent and convergent ducts Discussions

Write discussion on Airflow through divergent and convergent ducts
Your posts are moderated
Related Questions
advantages and disadvantages oh hot and cold die working in the subject of basic mechanical engineering

Calculate the maximum range when radar operates at 10GHz and has peak power=10 Mwatt,S/N ratio=10dB,antenna cross section=100 mm2,target cross section=10mm2.The gain of transmittin

5) Dupree Funds is considering the fees charged by two banks. First America charges a flat rate of $0.11 per payment and First Western requires a deposit of $500,000 (that does not

bit reversed process 10 point dft

If the light source in figure 12.1 (see figure below) of the Warren Smith text is replaced by a 100W light bulb, and the lens aperture is 20cm, what would the 1cm detector at point

Explain how a Q-meter can be used to measure resistance inductance and capacitance??

PRESSURE RELIEF VALVE The pressure relief valve shown in the figure. controls the oil pressure at the pre-set value demanded by the system. The valve is normally integral with

I have a 30'' simple span beam, braced at the supports only. Uniform load is 1200 plf. I need deflection limited to L/400. What size steel beam do I need?

Asymmetric Effect In general the axis of the propeller will be inclined upwards to the direction of flight due to the angle of attack of the aircraft.   This causes the dow

WHATIS LTE CODING TECHNIQUES USE FOR MOBILE SYSTEM