Aircraft characteristics - military and civil aircraft, Mechanical Engineering

Aircraft Characteristics

For planning and designing airport facilities, it is necessary to be conversant with the following important characteristics:

(a) speed

(b) size and dimensions

(c) weight, landing gear and tyre pressure

(d) turning radius

Figure may be referred.

Some of the characteristics are give in Table for some of the important aircraft types.

Table : Characteristics of some Important Aircrafts

2112_Aircraft Characteristics.png

Posted Date: 1/23/2013 1:31:51 AM | Location : United States







Related Discussions:- Aircraft characteristics - military and civil aircraft, Assignment Help, Ask Question on Aircraft characteristics - military and civil aircraft, Get Answer, Expert's Help, Aircraft characteristics - military and civil aircraft Discussions

Write discussion on Aircraft characteristics - military and civil aircraft
Your posts are moderated
Related Questions
Clutch Free Play Adjustment : A smooth operation of clutch ensures the smooth running of motorcycle; hence it is essential to maintain a proper clutch free play. STEPS

EQUIPMENT FOR RESISTANCE WELDING-Stored energy equipments   Energy can be stored and further utilised for welding. One method of storing energy is in capacitors electrostat

Q. Nitrogen storage and vaporizer? Bulk cryogenic storage of nitrogen must be located away from process equipment, preferably at the edge or corner of the process area where fi

Q. Define FLARE AND VRU SYSTEM? VRU, HP and LP Flare systems are used to collect normal and emergency releases from the process and recycle or dispose of them in a safe manner.

When was PDDI developed The PDDI interface was developed in connection with the ICAM project which was funded by the Air Force in order to improve the manufacturing methods in

Q. Purpose of Internal review? The Project Engineer in consultation with affected disciplines decides the timing of an internal review of IFR issue drawings. Each involved dis

Open belt drive: An open belt drive connects the two pulleys 120cm and 50cm diameter on parallel shafts which are apart 4m. The maximum tension in belt is 1855.3N. Coefficien

Q. Explain about Surface Preparation? All oil, grease, salts, and any other contaminants detrimental to the formation of a good coating bond or coating quality must be removed

LIMITATIONS OF GAS TUNGSTEN ARC WELDING (GTAW) It Produces lower deposition rates than consumable electrode arc welding processes. It Requires slightly more skill as comp

explain working and construction of locomotive boilers