## air gaps, Electrical Engineering

Assignment Help:
What is the main thing to look for in calculations of air gaps?

#### Latch - introductio to microprocessors , Latch A 8 bit  latch comprise...

Latch A 8 bit  latch comprises of transparent latch D flip  flop. It is commonly  used  to interface output  device with  microprocessor. A typical example of such 8 bit  latc

#### Find the resistance of 1 km of copper cable, Find the resistance of 1 km o...

Find the resistance of 1 km of copper cable having a diameter of 10 mm if the resistivity of copper is 0.017 x 10 -6 Ωm.

#### Calculate the voltage regulation, The per-phase synchronous reactance of a ...

The per-phase synchronous reactance of a three-phase, wye-connected, 2.5-MVA, 6.6-kV, 60-Hz turboalternator is 10. Neglect the armature resistance and saturation. Calculate the vo

#### \, Refer to Figure 100. Assume MKS units. Given: R1= 4, R2=14, R3= 9, I4...

Refer to Figure 100. Assume MKS units. Given: R1= 4, R2=14, R3= 9, I4= 8, I5= 7. Determine: Ieq, Req, and V3.

#### Thermal runaway, short notes on thermal runaway

short notes on thermal runaway

#### Ferromagnatic transformer, uses of ferromagnatic transformer

uses of ferromagnatic transformer

#### Obtain the waveforms, Q. (a) Consider a diode circuit with RC load as shown...

Q. (a) Consider a diode circuit with RC load as shown in Figure. With the switch closed at t = 0 and with the initial condition at t = 0 that vC = 0, obtain the functional forms of

#### PIC Controller Programming, I want to do programming in PIC controller and ...

I want to do programming in PIC controller and it needs to be done on particular development board.

#### Externally initiated signals - pins and signals , Externally  Initiated Si...

Externally  Initiated Signals Other than  interrupt  there are followings externally initiated  signals  available in 8085 microprocessor.

#### Estimate the bandwidth by using carsons rule, Let a message signal m(t) hav...

Let a message signal m(t) have a bandwidth of 10 kHz and a peak magnitude of 1 V. Estimate the bandwidth, by using Carson's rule, of the signal u(t) obtained when m(t) modulates a  