air conditioning systems., Mechanical Engineering

an air conditioning system is to take place in an outdoor air at 10 degrees celcius and 30% 0f relative humidity at a steady rate of 45 m^3/min and to condition it to 25 degrees celcius and 60% relative humidity . the outdoor air is first heated to 22 degrees celcius in the heating section and then humidified by the injection of hot steam in the humidifying section. assuming the entire process takes place at a pressure of 100 kPa, determine the rate of heat supply and the mass flow rate of the steam required
Posted Date: 11/1/2012 10:45:37 AM | Location : United States







Related Discussions:- air conditioning systems., Assignment Help, Ask Question on air conditioning systems., Get Answer, Expert's Help, air conditioning systems. Discussions

Write discussion on air conditioning systems.
Your posts are moderated
Related Questions
Classificatio n of I.C. Engines: IC engines are classified as follows: 1 . Nature of thermodynamic cycles as:  Otto cycle engine, Diesel cycle engine and Dual combus

Management of Financial Requirements:  To start an own workshop or any business you need monetary support. You need to ensure availability of the required money including working

Q. Design requirements for Aircraft Access? For some remote locations, provision may be required for occasional landing of aircraft during emergencies or executive visits. Thes

Determine the force: Determine the force P needed to start block B illustrated in Figure moving to the right if the coefficient of friction is 0.3 for all surfaces of contact.

Applications of seam welding Lap seam welding is used for the manufacture of cans, buckets and water tanks and for welding thin walled large diameter pipes. Mash seam welding

Show that the entropy maximum principle encountered in the study of isolated system is equivalent to the statement that the nonflow exergy of an isolated system is destined to decr

Determine the reactions at bea: A cantilever AB, 1.8 m long is fixed at A and carries uniformly distributed load of 20 kN/m over its entire length and a point load of 30 kN at

Particle in a Box 1 (from Dr. Liebman): You will remember that the energy of a particle in a 3 (and 2) dimensional box is defined by 3 (or 2) quantum numbers. This brings up the co

Initia l Tension in The Belt: Let T o = initial tension in belt T 1  = Tension in tight side T 2  = Tension in slack side T C  = Centrifugal Tension in belt T

(a) Oil, with density ρ= 900 kg/m 3 , and kinematic viscosity υ=0.00001m 2 /s, flows at the rate of 0.2m 3 /s through 500m of a cast iron pipe of diameter d=200mm. Using this infor