Air cannon launcher ansys analysis, engineering, Other Engineering

I''m doing a project that needs an ANSYS software for analysis calculation, is it possible to do me that if I provide you all the the information needed.
Thank you
Posted Date: 2/24/2012 12:00:44 AM | Location : United States

Related Discussions:- Air cannon launcher ansys analysis, engineering, Assignment Help, Ask Question on Air cannon launcher ansys analysis, engineering, Get Answer, Expert's Help, Air cannon launcher ansys analysis, engineering Discussions

Write discussion on Air cannon launcher ansys analysis, engineering
Your posts are moderated
Related Questions
Testing After Install After installation of a propeller, the engine must be ground run in order to check the propeller for correct function and operation.  Aircraft propeller in

Summing amplifier: As the title implies, this is an adding device.  The circuit can take any number of voltage inputs, and the output voltage is simply the sum of these inputs.

The operational amplifier : The integrated circuit operational amplifier is one of the most useful and versatile electronic devices available today.  The name 'operational ampl

Convert the following reduced bearings to whole circle bearings: N.36°16’E; (b) S.28° 14’ E. (c) S.47°26’W and (d) N.58°24’W

Steam enters in the turbine at 6 MPa and 450 deg C and expands at some intermediate pressure 60 % of steam is extracted and remainder expands to 10 kPa at this Investigate the effe

Explain how a Q-meter can be used to measure resistance inductance and capacitance??

Apu powerplant installation: The APU engine mounts consist of a number of supports with vibration isolators fitted to the end of each support. The tubular supports are bolted

Students are to undertake a tunnel blast design for the following conditions: • Tunnel is 5.5m wide by 5.5.m high • Rock is a sandstone with a UCS of 400 MPa • Drill hole diameter

micro structure of exogenous tree

Here, it is assumed that the crack is effectively longer than the value measured on the side of the specimen. If one assumes that it is longer by an amount Δ, then the new crack le