Aerodynamics, Mechanical Engineering

about assignment i sent
Posted Date: 10/22/2012 11:19:03 PM | Location : United States







Related Discussions:- Aerodynamics, Assignment Help, Ask Question on Aerodynamics, Get Answer, Expert's Help, Aerodynamics Discussions

Write discussion on Aerodynamics
Your posts are moderated
Related Questions
Important section of fly-overs and underpasses: Culverts : A structure having a waterway upto 5 m. Minor Bridge : A structure having a waterway of 6-30 m. Medium Si

Uniformly Distributed Load and Uniformly Varying Load: Uniforml y Distributed Load (UDL) A UDL is one which is spread over beam in such a manner that the rate of loading

Determine the angular acceleration of the motion: A flywheel of mass 15 kg and radius 20 cm is wound by a rope that carries a weight A of mass 5 kg at its free end as illustra

Calculate plastic zone: Calculate plastic zone ahead of crack in above problem if σY = 250 MPa. Solution From Eq. Here KI is taken as KI max since the plastic

Illustrate about the three authors of IGES In 1977, the three authors of The Initial Graphics Exchange Specification were recognized collectively for their contributions to the

Force required to start the roller: A roller shown in the figure given below is of mass 150Kg. What force T is required to start the roller over block A ? Sol.: Let

truss is shown in the following figure. Compute the horizontal deflection of joint D produced by both the load and fabrication error (bar AE is 40mm too long). For all bars, area A

Define Phase. A phase is a quantity of matter that is homogeneous during in chemical composition and physical structure. Determine if the matter is all gas, all liquid or all s

Hydrometer: Hydrometer (Figure) is used to measure the specific gravity of battery fluid (electrolyte). Figure: Hydrometer

Drainage of the Railway Track: It is necessary to keep the embankment free from water. This is done by providing side ditches, all along the edge of the embankment, and leadi