Advantages of laser welding process, Mechanical Engineering

Advantages of Laser Welding Process

 

1) Narrow deep penetration welds capable of being produced in atmosphere.

2) Low thermal distortion - due to less heat input and parallel sided fusion zone.

3) Narrow heat affected zone.

4) No contamination of filler or flames and hence environment friendly.

5) No filler metal required - it is possible to have filler materials, if necessary.

6) Welding can be done in inaccessible or hostile environments.

7) Multistation operation is possible using time sharing and beam splitting techniques.

Posted Date: 9/17/2012 8:19:29 AM | Location : United States







Related Discussions:- Advantages of laser welding process, Assignment Help, Ask Question on Advantages of laser welding process, Get Answer, Expert's Help, Advantages of laser welding process Discussions

Write discussion on Advantages of laser welding process
Your posts are moderated
Related Questions
5. Calculate and draw the Shear force and Bending moment diagrams for the loaded beam and determine the maximum moment M and its location x from left end

Q. Module Site Installation Preparation? The following tasks shall be accomplished at the Facility site prior to setting the modules on the piles: After module support piles

Q. Material Selection for Insulation? Material for 15ºC to 650ºC temp range is Calcium Silicate, Manville Thermo-12 or approved equivalent. Material for -18ºC to 230ºC temp.

Estimate the Weight of the Casting A Yoke casting shown in Figure is to be produced by sand casting process. Estimate the weight of the casting if the density of the material

Explain construction and working of Belt transmission type Dynamometer?

Find out the centroid of the shaded area: Find out the centroid of the shaded area illustrated in Figure (a). Solution The shaded area A may be considered as the

Find out the moment of inertia  of a semicircle: Find out the M. I. of a semicircle ABM around its periphery AB and also around centroidal axes x and y as illustrated in Figur

Q. Alloy materials control? All low alloy and high alloy equipment components including fittings, flanges and sections of pipe and all welds shall be individually tested by Ven

Vibration Damping : Suitable mechanism should be incorporated within the clutch to eliminate (to reduce it drastically) noise produced in the transmission. Size : The size of

HOW DO I DESIGN A COMPONENT FOR IMPACT STRENGTH FOR IMPACT LOAD AT LOWER TEMPERATURE