Advantage of flash butt welding, Mechanical Engineering

Advantage of flash butt welding

1. Higher weld strength

2. Higher production rate

3. Better heat concentration

4. Simple weld surface preparation

5. Wide range of metal welded including dissimilar metals.

6. Cleaner weld because of the impurities being thrown out.

7. Consistency of weld results

8. Economy, easy and simple weld control.

9. Greater degree of flexibility using preselected programme

Posted Date: 9/17/2012 4:01:21 AM | Location : United States

Related Discussions:- Advantage of flash butt welding, Assignment Help, Ask Question on Advantage of flash butt welding, Get Answer, Expert's Help, Advantage of flash butt welding Discussions

Write discussion on Advantage of flash butt welding
Your posts are moderated
Related Questions
Compute depth of yielding in the hollow shaft: A solid shaft 80 mm diameter is solid for a certain length from one end but hollow for the remaining length along inner diameter

Braking System: A brake is a component of a motorcycle which is used to apply frictional resistance to a moving vehicle to stop or retard it by absorbing its kinetic energy. The f

a beam ABC is simply supported at A and C and caries a couple equal to 100kN applied clockwise at B

What is Metal Cutting Tool? A cutting tool (or cutter) is any tool which is used to remove material from the work piece by means of shear deformation. Cutting may be completed

sand casting and its type

Geometric Defects   Undercut Undercut represents a depression into the base metal adjacent to the toe of the weld and if it forms a notch, it is a potential danger for th

Explain Cutting Speed - Cutting Parameters It is relative speed (V 1 ) between wheel and the Work piece. It is expressed in m/sec.   V=Cutting speed=V 1   =

Ratio of belt tension: For Open belt drive:   Angle of contact (θ) for larger pulley = ∏ + 2α Angle of contact (θ) for smaller pulley = ∏ - 2α For cross belt drive:

Determine the number of cycles - crack propagation: The plate of above Example  contained a crack of 50 mm length in the centre before it was subjected to cyclic stress. Deter

What is Time-Study ? How the standard time is determined in Time-Study ? What are the Merit-Rating ? Illustrate various methods of Merit-Rating. Describe the Break-Even-Analy