Add the contents of register - add instruction , Electrical Engineering

Add the Contents of Register 

This  instruction is used to add the contents  of register R with  the contents  of accumulator  and result  of operation is stored  in the accumulator after addition. Here register Ra may be any  one  of the A, B, C, D, E ,H, or L registers. The  instruction format  is

ADD  R                 [ A - A+R]

Flags : All  are modified according  to the results.

Posted Date: 4/4/2013 6:18:37 AM | Location : United States







Related Discussions:- Add the contents of register - add instruction , Assignment Help, Ask Question on Add the contents of register - add instruction , Get Answer, Expert's Help, Add the contents of register - add instruction Discussions

Write discussion on Add the contents of register - add instruction
Your posts are moderated
Related Questions
Peak inverse Voltage   Peak  inverse voltage is   important parameter in the design of rectifier circuit. PIV is the maximum  voltage that appears across the device  during its

Explain How to Represent Power Lines? The equivalent circuit of a power line depends on the length of the line and on the accuracy of the model required. In general, any power

What is meant by Wait State? This state is used by slow peripheral devices. The peripheral devices can transmitted the data to or from the microprocessor by using READY input l

what ternary alloy, composition and binary substrate can be used for an LED at 1.55 µm optical fiber windo

Q. Process of Amplitude Modulation? In AM the message signal is impressed on the amplitude of the carrier signal. There are several different ways of amplitude modulating the c

Q. The DeMorgan's theorems suggest that the basic logic operations can be realized by use of inverters and NAND gates only. For the circuits shown in Figure,  find the truth table,

Define intermodal dispersion? Dispersion of the transmitted optical signal causes distortion for both digital and analog transmitted signal. The dispersion causes broadening o

ELEC 132 COURSEWORK – ADC This work will be assessed based on program demonstration (during lab sessions) and design. You will also have to submit your c-source codes as word o

A 10-hp, 230-V, 500-r/min shunt motor, having a full-load armature current of 37 A, is started with a four-point starter. The resistance of the armature circuit, including the inte

What is the disadvantages of diodes as a series element in a clipper?