Add register and carry with accumulator, Electrical Engineering

Add Register and Carry with Accumulator

The contents  of register R and the  carry flag are added to the  contents of the  accumulator  and result of  addition  is also  stored in accumulator. This instruction is generally used in multisystem  addition .

ADC R  ( A- A + R + CY

Flags : All  flags are modified  according to the result .

Posted Date: 4/4/2013 6:23:28 AM | Location : United States







Related Discussions:- Add register and carry with accumulator, Assignment Help, Ask Question on Add register and carry with accumulator, Get Answer, Expert's Help, Add register and carry with accumulator Discussions

Write discussion on Add register and carry with accumulator
Your posts are moderated
Related Questions
Q. Explain about Transistor Amplifiers? Amplifiers are circuits that produce an output signal which is larger than, but proportional to, an input signal. The input and output s

Research and recommend a sensor for a real full size conveyor system of approximately 1000mm width to detect objects of varying size passing along it. Discuss the suitability of th

Q. (a) An audio amplifier with R i = 10 k, R o = 0, and ¯A(ω), as shown in Figure (a), is used in the circuit shown in Figure with R S = 1 k,R L = 16 , and C = 0.2 µF. Sk

what are the grond clearance for 220KV overhead transmission lines?

why Direct current flow through semiconductors but alternating current cannot flow?


Linear Equalizer and Decision Feedback Equalizer Simulation and Performance Comparison In this project , performance of decision feedback equalizer is analyzed,

Q. Consider the magnetic circuit shown in Figure. Assume the relative permeability of the magnetic material to be 1000 and the cross-sectional area to be the same throughout. Deter

Explain the purpose of the I/O instructions IN and OUT. The IN instruction is used to move data from an I/O port into the accumulator. The OUT instruction is used to move d

R-2R LADDER CONVERTER Figure shows a 4-bit R-2R ladderD/Aconverter,which contains a reference voltage source, a set of four switches, two resistors per bit, and an op amp. The