Accumulator - registers , Electrical Engineering

Assignment Help:

Accumulator - Registers

It is an  8 bit  registers which  is the most  important  part of  the arithmetic  and logic unit.  It is used to store  8 bit  data.  The result  of arithmetical and logical operations are stored  in the  accumulator. It is  also  used to receive data from  input  port to microprocessor  and  to sends data to output  from  microprocessor.  It is  referred  as register   A in  the program.

The bits of any register are referred  as D7 -D0 as shown in figure.

254_Accumulator.PNG

                                                   Figure Bits of Any Register


Related Discussions:- Accumulator - registers

Addition of two sinusoids, Connect the 2 kHz (sin ωt) signal to input A of ...

Connect the 2 kHz (sin ωt) signal to input A of the "Adder" module Connect input B to ground (GND). Connect the outputof the"Adder"(GA+gB) to input A-CH1 of "Scope Selector".

Three-phase Portable Bench Power Supply, hi can you help me to create a dc...

hi can you help me to create a dc to 3 phase ac circuit which can exceed at any point: 50V and 20A and 400W maximum. The output should be variable from about 0 – 25V per phase, wi

Distribution centre capacity, Discuss the following points with regard to t...

Discuss the following points with regard to the Company selecting Jebel Ali Free Zone as its Middle East base.  (a) How is a company likely to enhance its supply chain by using

Define embedded system according to wayne wolf and todd, Define the term em...

Define the term embedded system according to Wayne Wolf and Todd. According to Wayne Wolf: This is any device which includes a programmable computer but is not itself intend

Write a short note on heat sink, Q. Write a short note on heat sink For...

Q. Write a short note on heat sink For transistors handling small signals ,the power dissipated at the collector is small.Such transistors have little chances of thermal runawa

What do you mean by direct coupling, Q What do you mean by Direct coupling?...

Q What do you mean by Direct coupling? In this method the a.c. output signal is fed directly to the next stage. No reactance is included in this coupling network. Special d.c.

Static rotor resistance control methods - motor control , Static Rotor Res...

Static Rotor Resistance Control Methods This method is used only for slip  ring induction motor in SRIM  3- phase  variable  resistor can be inserted in the rotor  circuit and

Network analysis, expain how to do proper initial approximatio for the give...

expain how to do proper initial approximatio for the given cct....... by a example

Derive an expression for the electric force, Q. A two-winding system has it...

Q. A two-winding system has its inductances given by where k 1 and k 2 are constants. Neglecting the winding resistances, derive an expression for the electric force when

Determine impedance - resultant current and power factor, Determine Impedan...

Determine Impedance - Resultant current and Power factor: In series R-L circuit, illustrated in Figure , Determine 1.      Impedance, 2.      Resultant current, 3.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd