8 bit data to memory - move immediate instruction , Electrical Engineering

8 bit  data to memory

This form  of the  instruction is used to  copy 8 bit  data directly  to the memory  location pointed  by register pair HL.  The instruction  format is

MVI M 8 bit data                       ( [HL] - 8 bit  data )

Posted Date: 4/4/2013 5:31:49 AM | Location : United States







Related Discussions:- 8 bit data to memory - move immediate instruction , Assignment Help, Ask Question on 8 bit data to memory - move immediate instruction , Get Answer, Expert's Help, 8 bit data to memory - move immediate instruction Discussions

Write discussion on 8 bit data to memory - move immediate instruction
Your posts are moderated
Related Questions
1. Suppose the California government sets aside a square patch of land that is 10 kilometers on each side and plans to use this land to generate electrical power with wind turbines

Q. A synchronous motor operates continuously on the following duty cycle: 50 hp for 8 min, 100 hp for 8 min, 150 hp for 10 min, 120 hp for 20 min, and no load for 14min. Specify th


Regions of operation: Applied voltages Mode E Forward active E C Saturation E > B

Interfaced 2k X 8 (i.e 2716) EPROM using multiple input NAND gate decoder for memory locations FF800H-FFFFFH. Simple NAND gate Decoder:  While the 2k x 8 EPROM is used so addre

Transmission Through a LiNb0 3 Plate Examine the transmission of an unpolarized He-Ne laser beam (?o= 633 nm) normally incident on a LiNb0 3 plate (ne = 2.29, no = 2.20) of thickn

Q. With suitable diagram explains the working of a sweep frequency generator. Sol. A sweep frequency generator or sweeper is a special type of signal generator in which the o

Determine Impedance in each branch - delta connection: A delta connected balanced 3-phase load is supplied from a 3-phase 400 V supply. The line current is 30 Amp and the powe

Define Hysteresis Hysteresis is the 'lagging' effect of flux density B whenever there are changes in the magnetic field strength H. When an initially unmagnetized ferromagnetic

Question: a) For the circuits shown in figure a and in figure b, show the output voltage waveform V0(t) if a sinusoidal signal with peak value of 5V is applied and the dc suppl