# Project, Electrical Engineering

#I need some guides in order to build a circuit that will be beneath a machine and turn that machine left/right/up/down
Posted Date: 10/11/2012 6:10:58 PM | Location : United States







Related Discussions:- # Project, Assignment Help, Ask Question on # Project, Get Answer, Expert's Help, # Project Discussions

Write discussion on # Project
Your posts are moderated
Related Questions
Q. For the circuit of Figure, determine and sketch i L (t) and vC(t) for inductance values of (a)3/4 H, (b) 2/3 H, and (c) 3/17 H. Note that the inductance values are chosen her

solve problem by neural network using matlab code

Design a mod-15 counter. Explain the various steps in designing the counter

Consider a forward-biased diode with a load resistance. Let the static volt-ampere characteristic of the diode be given by Equations, and typically represented by Figure. (a) Fo

explain all the components involved in transmission of electricity

Boost Converter The boost  converter has its  output  voltage always  greater than input  voltage like  a buck  converter boost  converter has two  modes.

Q. Commercial FM radio broadcasting? Commercial FM radio broadcasting utilizes the frequency band of 88 to 108 MHz for the transmission ofmusic and voice signals. The carrier

A DT LTI system has the following impulse response: h(n)=[cos(pi/+delta(n)] u(n-3)u(n-2) (a) Find the system’s frequency response h(e^jw ). (b) Sketch the magnitude and phase respo

Design a low noise amplifier using an Infineon RF transistor BFP640. The amplifier is to be used to amplify the L2 GPS signal and so the centre frequency is 1227MHz and bandwidth 4

Q. Determine the transfer function C(s)/R(s) of the nested-loop feedback system shown in Figure.