LED should also show the rounded percentage , Electrical Engineering

The LEDs should also show the rounded percentage of the full scale output. Since there are 8 LEDs every one represents 12.5%. Though, since we want the rounded percentage the LED on the LSB should be illuminated if the voltage is above 6.25% (312mV) and the next LED should illuminated if the voltage is above 18.75% (937mV) etc.

Posted Date: 3/18/2013 8:15:13 AM | Location : United States







Related Discussions:- LED should also show the rounded percentage , Assignment Help, Ask Question on LED should also show the rounded percentage , Get Answer, Expert's Help, LED should also show the rounded percentage Discussions

Write discussion on LED should also show the rounded percentage
Your posts are moderated
Related Questions
Buck Converter In buck  converters the output  voltage is  always  less than the  input  voltage. The basic  circuit  of buck converter is shown  in figure. The operation of th

Q. Discuss the nature of sinusoidal signal? Discuss the nature of evenness and oddness of: (a) The sinusoidal signal x(t) = A cos(2πf 0 t + θ). (b) The complex exponentia

STC Set Carry Instruction This instruction  sets   the carry  flag  to 1. The  instruction format is STC Flags except carry no other  flags are affected

Explain DJNZ instructions of intel 8051 microcontroller? a) DJNZ Rn, rel Decrement the content of the register Rn and jump if not zero. b) DJNZ direct, rel Decreme

Q. What is a darlington pair?                             The Darlington circuit consists of two cascaded emitter followers with infinite emitter resistance in the first stage.

1. Introduction : Theory:   The voltage measured across a load follows the Ohm's law which says that the current passing through a conductor between two points is direct

A 13.8 kV feed er circui t breaker has a 600:5 multira tio curr ent transform er with charact eristics as show n in Figure 5.11. Th e max - imum load on the feed er is 80 A pri mar

I want simulink model for carrier based pwm method

Flag Registers Flag  register  is also an  8 bit  register. Out of 8 bit  five are  defined as flags to indicate status  of the accumulator  hence it is also called status reg

Q A60-Hz, 100-kVA, 2400/240-V(rms) transformer is used as a step-down transformer from a transmission line to a distribution system. Consider the transformer to be ideal. (a) Fi