Body projected vertically,neglect gravity.will it fall back, Mechanical Engineering

Qusetion: A body when projected vertically up covers a total distance s, during its time of flight. If we neglect gravity then how much distance, the particle will travel during the same time. Will it fall back?

Sol- If we neglect gravity then body will not come back and the distance travelled will be intial velocity*time.

Posted Date: 3/7/2013 6:46:06 AM | Location : United States







Related Discussions:- Body projected vertically,neglect gravity.will it fall back, Assignment Help, Ask Question on Body projected vertically,neglect gravity.will it fall back, Get Answer, Expert's Help, Body projected vertically,neglect gravity.will it fall back Discussions

Write discussion on Body projected vertically,neglect gravity.will it fall back
Your posts are moderated
Related Questions
Select a standard rolled steel I-section for the simply supported beam shown in figure below.  Select an appropriate factor of safety and material strength.  Include references for

(a) List several advantages and disadvantages of using transparent polymeric materials for eyeglass lenses. (b) Cite four properties (in addition to being transparent) that are

Q. Illustrate process of Radiographic Examination? Radiographic examination of welded joints shall be performed when required by the Code or additionally when specified in this

Determine the loss-by-defect and loss-by-dispersion Given, Annual production = 1,00,000 units Specification = 20 ± 4  i.e. m = 20, Δ = 4 Cost of repairing or resetting a

what is Direct and Reverse crank method of balancing

an elctric current is passed through a wire 1mm in diameter and 10mm long. the wire is submerged in liquid water at atmospheric pressure and current is increased until the water bo

Concentrate d or Point Load: How many types of load are acting on the beam? A beam is usually horizontal and the loads acting on beams are usually vertical. The followi

I have an assignment on kinematic chains.I have to tell the type of chain whether it is locked,constrained or unconstrained?? I am facing problem in counting number of joints,pair

An engine uses air as the operating substance. At the beginning of compression the pressure is 90 KN /m 2 and the temp. is 40 0 C. During the adiabatic compression, the volume is

what is the role of a correction couple and how does it come into picture in dynamically equivalent system?