atex equipment, Electrical Engineering

Assignment Help:
I have an enclosure which doesnt comply with the atex directive, they want to install it in outside in a safe area of an offshore platform. They have produced an atex cert and want it on the atex register. I see they have two options get rid of the cert or change the enclosure to one that conforms to the atex directive??

Related Discussions:- atex equipment

Low and high pass filters - calculate the cutoff frequencies, At the comple...

At the completion of this unit, you will be able to determine the cutoff frequencies and attenuations of RC and RL low- and high-pass filters by using test circuits. UNIT FUNDA

Determine the resonant frequency and bandwidth, (a) For a series RLC resona...

(a) For a series RLC resonant circuit, find an expression for the voltage across the resistance VR and obtain the ratio V R /V S , where V S is the applied voltage. Identify the e

Dsp., fir and iir filter design

fir and iir filter design

Find the force between the wires, Q. A magnetic force exists between two ad...

Q. A magnetic force exists between two adjacent, parallel current-carryingwires. Let I 1 and I 2 be the currents carried by the wires, and r the separation between them. Making u

For zero flag , For zero flag  CZ ( Call  on Zero )  CNZ ( Call on no...

For zero flag  CZ ( Call  on Zero )  CNZ ( Call on no zero ) Instructions CZ call the  subroutine  from the  specified  memory location if zero flag is set  (Z=1). The i

Evaluate the condition on the amplifier noise temperature, Alow-noise trans...

Alow-noise transducer is connected to an instrumentation system by a cable that generates thermal noise at room temperature. The information-bearing signal has a bandwidth of 6 kHz

Installation of meters and verification of connections, Installation of Met...

Installation of Meters and Verification of Connections Apart from testing and calibrating the meters they must be properly installed as per the links diagram. The points in wh

Works, Microprocessor and its Applications

Microprocessor and its Applications

Determine the line-to-line voltage at the load terminal, Q. A balanced delt...

Q. A balanced delta-connected load has a per-phase impedance of 45 60° . It is connected to a three-phase, 208-V, 60-Hz supply by a three- phase feeder that has a per-phase impeda

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd