Reference no: EM131077025
1) When the lights are turned off in a building, an exit door light is to remain on for an additional 2 min, and the parking lot lights are to remain on for an additional 3 min after the door light goes out. Write a program to implement this process.
2) Write a program to implement the process illustrated in Figure 1. The sequence of operation is to be as follows:
- Normally open start and normally closed stop pushbuttons are used to start and stop the process.
- When the start button is pressed, solenoid A energizes to start filling the tank.
- As the tank fills, the empty level sensor switch closes. When the tank is full, the full level sensor switch closes.
- Solenoid A is de-energized.
- The agitate motor starts automatically and runs for 3 min to mix the liquid.
- When the agitate motor stops, solenoid B is energized to empty the tank.
- When the tank is completely empty, the empty sensor switch opens to de-energize solenoid B.
- The start button is pressed to repeat the sequence.
3) Write a program to implement the process illustrated in Figure 2. A company that makes electronic assembly kits needs a counter to count and control the number of resistors placed into each kit. The controller must stop the take-up spool at a predetermined amount of resistors (100). A worker on the floor will then cut the resistor strip and place it in the kit. The circuit operates as follows:
- A start/stop pushbutton station is used to turn the spool motor drive on and off manually.
- A through-beam sensor counts the resistors as they pass by,
- A counter preset for 100 (the amount of resistors in each kit) will automatically stop the take-up spool when the accumulated count reaches 100.
- A second counter is provided to count the grand total used.
- Manual reset buttons are provided for each counter.
4) Write a program to implement the box-stacking process illustrated in Figure 3. This application requires the control of a conveyor belt that feeds a mechanical stacker. The stacker can stack various numbers of cartons of ceiling tile onto each pallet (depending on the pallet size and the present value of the counter). When the required number of cartons has been stacked, the conveyor is stopped until the loaded pallet is removed and an empty pallet is placed onto the loading area. A photoelectric sensor will be used to provide count pulses to the counter after each carton passes by. In addition to a conveyor motor start/stop station, a remote reset button is provided to allow the operator to reset the system from the forklift after an empty pallet is placed onto the loading area. The operation of this system can be summarized as follows:
- The conveyor is started by pressing the start button.
- As each box passes the photoelectric sensor, a count is registered.
- When the present value is reached, the conveyor belt turns off.
- The forklift operator removes the loaded pallet.
- After the empty pallet is in position, the forklift operator presses the remote reset button, which then starts the whole cycle over again.
Write an research paper on downfall of president in brazil
: Write an eight pages Political science research paper on downfall of President in Brazil.
|
The parent claim the child as a dependent
: The child age 25, the child earns $3900, the parent provide more than 50% the support, the child lives in another state.Can the parent claim the child as a dependent? What's the parent filing stuatus?
|
Calculate auto-thermal reforming material balance for plant
: calculate Auto-thermal reforming material balance for the plant ( hand calculation as well as summary table use Autothermal reforming technology )
|
The urchase price at nominal intrest rate
: a new house cost $178,000. the bank will loan 90% of the urchase price,at nominal intrest rate of 10.75% compounded weekly and monthly payments will be made. We want to pay the house off in 25 years. What would the monthly payments be?
|
Write a program to implement the process
: When the lights are turned off in a building, an exit door light is to remain on for an additional 2 min, and the parking lot lights are to remain on for an additional 3 min after the door light goes out. Write a program to implement this process
|
Show the graphical presentation of exchange for goods
: Suppose the firms in the economy were to produce fewer goods and services .How do you think would affect house hood spending on goods and services(use the circular flow model to analyze this question)
|
Account appears in the ledger prior to recognizing the jobs
: The following account appears in the ledger prior to recognizing the jobs completed in August: Work in Process Balance, August 1 $ 60,000 Direct materials 325,000 Direct labor 462,000 Factory overhead 210,000 Jobs finished during August are summar..
|
Attestation for human reference administration capacity
: Goals and techniques that is ordinary in the work power. From this data, construct an objective attestation for the human reference administration capacity of a considerable firm of your decision. This is your chosen and will be utilized as an est..
|
Economic entity concept and the parent company concept
: 1. the difference between the economic entity concept and the parent company concept approaches to the reporting of subsidiary assets and liabilities in the consolidated financial statements on the date of the acquisition.
|