+1-415-670-9189
info@expertsmind.com
Wind turbine
Course:- Mechanical Engineering
Reference No.:- EM13416




Assignment Help
Expertsmind Rated 4.9 / 5 based on 47215 reviews.
Review Site
Assignment Help >> Mechanical Engineering

Wind turbines are becoming more and more common as a method of energy production, wind turbines by their very nature are dynamic and are subject to and create their own internal and external kinematics and kinetics.

Your task is to pick a section of Victorian coastline and erect a wind turbine/s that is capable of producing 100 kW every hour averaged over one week. Your turbine will be of any style and design to suit the circumstances; you will need to consider wind conditions to electrical generation.  You will need to looks at both the kinematics and the kinetics of the motion.




Put your comment
 
Minimize


Ask Question & Get Answers from Experts
Browse some more (Mechanical Engineering) Materials
A stream of gas flowing at 15,000 scfm contains 20 ppm of toluene. Assuming the process operates 8500 hours per year, calculate the potential emissions of toluene, tons/year.
Two kilograms of water, initially a saturated liquid at 100 kPa, are heated to saturated vapor while the pressure is maintained constant. Determine the work and heat transfer
Air at a pressure of 1 ATM, a temperature of 15° C, and a velocity of 10 m/s flows over a 3 m long flat plate that is heated to a uniform temperature of 140° C. What is the lo
Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 10MPa, 450C and 83 m/s, and the exit conditions are 10kPa, 92 percent and 42 m/s. The
Specify the standard 3V belt length (from Table 7-2) that would he applied to two sheaves with pitch diameters of 5.25 in and 13.95 in with a center distance of no more than
An air standard dual cycle operates with a compression ratio of 15. At the beginning of the compression the conditions are 17°C, 0.95 bar, and 3.8L. The amount of heat added i
If N = 120 chips attached to the outer surfaces of the heat sink maintain an approximately uniform surface temperature of T 2 = 50°C and all of the heat dissipated by the ch
A piston-cylinder device contains steam that undergoes a reversible thermodynamic cycle. Initially the steam is at 400 kPa and 350C with a volume of 0.3 m^3. The steam is firs