Which is supported on the opposite side is the engine mount

Assignment Help Mechanical Engineering
Reference no: EM13625428

A 2 cm by 2 cm by 2 cm rubber engine mount (E = 30 MPa, Poisson ratio = 0.4999) must support a 300 kg motor. What (maximum) deflection (in cm) will occur for a.) vertical and b.) horizontal mountings. Assume the weight is uniformly distributed across a face of of the material. Note, in the vertical mount the motor sits atop the mount, while in the horizontal geometry the motor is mounted on the side of the mount, which is supported on the opposite side. c) Is the engine mount properly designed for horizontal mounting? Explain briefly why.

Reference no: EM13625428

Questions Cloud

The density of air is to be determined by measuring its : the density of air is to be determined by measuring its pressure and temperature for insertion in the ideal gas
The y and z dimension of the slab are very large compared : a uniformly charge slab of insulating material has thickness 2d and is oriented so that is faces are parallel to the
An 78-kg jogger is heading due east at a speed of 28 ms a : an 78-kg jogger is heading due east at a speed of 2.8 ms. a 56-kg jogger is heading 42 deg north of east at a speed of
Consider two identical 76 microcoulomb point charges placed : consider two identical 76 microcoulomb point charges placed 73 cm apart. let there be a 1 nc 1 nanocoulomb 1e-9
Which is supported on the opposite side is the engine mount : a 2 cm by 2 cm by 2 cm rubber engine mount e 30 mpa poisson ratio 0.4999 must support a 300 kg motor. what maximum
Agents at an insurance company office in a small town : agents at an insurance company office in a small town process an average of fifteen auto insurance claims per week.
A converging lens with focal length of 20cm is located 10 : a converging lens with focal length of 20cm is located 10 cm to the left of a diverging lens having a focal length of
Determine the minimum number of expansion joints required : a bridge to be fabricated of steel girders is designed to be 500 m long and 12 m wide at ambient temperature assumed 20
The following is the heart rate for 10 randomly selected : the following is the heart rate for 10 randomly selected patients on the unit. find the mean variance and standard

Reviews

Write a Review

 

Mechanical Engineering Questions & Answers

  Questions on entropy, exergy, cycles, otto cycle

Questions set on  Entropy,  Exergy,  Cycles, Otto Cycle,  Rankine Cycle.  In a coal fired thermal power station, indicate where the exergy contained in the coal is destroyed. For each exergy destruction mechanism, explain whether there is a small..

  There are two connected spur gears attached to a fixed

there are two connected spur gears attached to a fixed board at points a and b. the assumptions of the system are that

  Find the heat transfer and work for each component find

a geothermal heat pump is used to provide a house with 5 kw of heating. the house is at 25degc and the ground

  Use thin airfoil theory to show that pressure coefficient

Use thin airfoil theory to show that the pressure coefficient across the length of the ellipse in the stream-wise direction is constant when it is assumed T

  A working fluid at 500kpa 400c 67315k is in a

a working fluid at 500kpa 400c 673.15k is in a piston-cylinder equipment with an initial volume of 0.9 m3. the fluid

  Determine be naturak frequency of the system

A 0,5Kg mass attached linear spring suffress 01 N/m. Determine be naturak frequency of the system in hortz e reapert this calculation for a mass of 50Kg and a suffress of 10N/m and compare your result to that of part.

  Explain the true altitude of the plane above sea level

What is the true altitude of the plane above sea level? What would be the indicated altitude after landing at an aerodrome located at sea level? (Gas const = R=288 J/KgK)

  What is the required impeller diameter ratio between the

a 20 mw radial flow hydraulic turbine is to be designed with a head of 70 m and a speed of 90 rpm. a geometrically

  A state runs a lottery in which 6 numbers are randomly

a state runs a lottery in which 6 numbers are randomly selected from 40 without replacement. a player chooses 6 numbers

  Determine the resultant of the three forces

Determine the resultant of the three forces F1 = 2.0i + 3.3j - 2.6k; F2 = - i + 5.2j - 2.9k; and F3 = 8.3i - 6.6j + 5.8k, which are concurrent at the point (2, 2, -5.). The forces are in Newton's and the distances are in meters.

  Vinegar is a solution of acetic acid dissolved in water a

vinegar is a solution of acetic acid dissolved in water. a 5.54 g sample of vinegar was neutralized by 30.10ml of .100

  Evaluate the work required and the heat transfer

Kinetic and potential energy effects can be ignored. Evaluate the work required and the heat transfer, each in kW.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd