Which communitys transportation is more environmentally

Assignment Help Civil Engineering
Reference no: EM13557056

Imagine two small towns of 1,000 people: Blacktop and Parktown. In the urban sprawl that is Blacktop, all the residents own fuel-efficient cars (15 km/liter) and travel an average of 20,000 km per year. Over in Parktown, the situation is somewhat different. Good public transport and well-planned amenities mean that only half the inhabitants need a car. Those that do own a car tend not to need it so often and therefore replace it less frequently. Each car-owner drives an average of 10,000 km per year. However, their older-model vehicles are less fuel efficient (10 km/liter) than those in Blacktop. Which community’s transportation is more environmentally sustainable?

Reference no: EM13557056

Questions Cloud

What is the displacement and acceleration of the automobile : What is the displacement and acceleration of the automobile at t-15, 45, and 50 seconds. Construct a v--t graph from 0 to 50 seconds.
What is the minimum radius of curvature for a curve such : The coefficient of friction between a car’s tires and the road is such that the car can generate a maximum deceleration of 1.1g without experiencing slip. What is the minimum radius of curvature
Determine the optimal amount of water that will be drawn : The town needs a total of 2 mgd. The capacity of well 1 is 5 million gallons per day, and that of well 2 is 10 mgd. Using calculus (hint: calculus with substitution), determine the optimal amount of water that will be drawn from each well if the town..
How much will it cost the state to fund the project : Northern Tundra Telephone (NIT) has received a contract to install emergency phones along a new 100-mile section of the Snow-Moose Turnpike. Fifty emergency phone systems will be installed about 2 miles apart
Which communitys transportation is more environmentally : Imagine two small towns of 1,000 people: Blacktop and Parktown. In the urban sprawl that is Blacktop, all the residents own fuel-efficient cars (15 km/liter) and travel an average of 20,000 km per year.
Compute the value of the objective function and decision : Solve the following LP using the graphical method (graph sheets attached). Compute the value of the objective function and decision variables at optimality, and indicate which statement best describes the solution.
How much could he exert if he moved his hands to the ends : A plumber places his hands 18 inches apart on a pipe threader and can push (and pull) with 80 lb of force. What couple moment does he exert? How much could he exert if he moved his hands to the ends so that his hands are 254 inches apart?
What will the lowest dissolved oxygen concentration : A wastewater is discharged to a stream with a reoxygenation constant of 0.5 day-1 and a velocity of 1 m/sec. The oxygen saturation concentration in the stream is 11 mg/L.
Calculate the horsepower required assume concentric cylinder : Assuming a density of 120 lb/ft*3 for masonry brickwork,determine the maximum height of a brick wall if the allowable compressive stress is limited to 150 psi,and the brick is (a) four inches wide and (b) six inches wide.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find temperature to achieve the required concentration

The initial concentration of carbon in the metal is 0.1wt%. We first do an experiment by applying a concentration of 5%wt of carbon at the surface of a similar slab and maintaining the system at 900 K for an hour.

  Plot the shape of water surface from the center to radius

a whirlpool is modeled as the combination of a free and a forced vortex. the maximum velocity in the whirlpool is 10 m/s, and the radius at the juncture of the free and the forced vortex is 10m.

  How long did take for the rocket to reach that max height

At that time, there is no more fuel in the rocket engine and the rocket continues upwards in free fall (g=0 ft/sec/sec). (a) How high will the rocket reach before it begins to fall back to the campus

  What are the legal ways of doing disposal in the valley

A tank with a volume of 5,000 gal contains salt solution at an initial concentration (C0*) of 70,000 mg/L, but the concentration in the tank (C) needs to be reduced to 500 mg/L. Two approaches are being considered

  Find the minimum theoretical wall thickness

A flow of 600cfs is measured at a depth of 3.4 ft in trapezoidal channel with bottom width of 25ft and side slopes of 3:1(h:v). The channel reach has a slope of .002. Estimate the channel roughness.

  Find si value of absolute pressure corresponding to vaccum

What is the SI value of absolute pressure corresponding to a vacuum pressure of -10 inches of water. Assume the location is Moscow, Idaho. What is the SI value of gage pressure corresponding to a pressure 14 psia. Assume the location is Denver, Colo..

  What is the flow rate for a normal depth of 1m-2m and 4m

A trapezoidal channel with base width 5m and side slopes 2 horizontal to 1 vertical, slopes at 0.0005. If n=0.010, what is the flow rate for a normal depth of 1m, 2m, 4m

  Find the value of the angle at which the projectile is fired

A projectile is fired with an initial velocity of 800 ft/s at a target B located 2000 feet above the gun A and at a horizontal distance of 12,000 feet. Neglecting air resistance, determine the value of the angle at which the projectile is fired.

  Describe what is the maximum acceptable internal pressure

of 2640 psi with a factor of safety of 2.0 with respect to yielding. the yield stress of the steel is 65,000 psi in tension and 32,000 psi in shear. the diameter of the tank is 7.0 in. the minimum required wall thickness is 0.289 in.

  Determine what is the degree of curve by chord definition

For a circular curve with a radius R of 400 meter, what is the degree of curve by (a) arc definition and (b) chord definition

  What will be the effect of heating the lid and jar

For a rubber component that, in its final form is to be vulcanized, should vulcanization be carried out prior or subsequent to the forming operation? Why?

  Determine the foundation soils allowable bearing

A square footing 2 meters by 2 meters is to be constructed 1.22 meters below the ground surface. The groundwater table is located 1.82 meters below the ground surface. The subsoil consists of a uniform, medium dense, cohesionless soil with the follow..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd