What would the spindle diameter need to be in order to move

Assignment Help Civil Engineering
Reference no: EM13315992

The crane hoists a uniformly distributed load C. the two identical motors at A an power through gearboxes operating at maximum output speed of 100 rpm.the load is lifted by winding cable onto spindles attached to the output shaft of each gear box. The spindles both have the same diameter, d. What would the spindle diameter need to be in order to move with a velocity of 1 m/s?

Reference no: EM13315992

Previous Q& A

  What is the persons acceleration

If a 60.0 kg person slides down an incline angled 25%u02DA below the horizontal and friction IS present with a coefficient of kinetic friction equal to k = 0.450. What is the person's acceleration

  Compute the amount of manufacturing overhead

For Karr Company, the predetermined overhead rate is 140% of direct labor cost. During the month, Karr incurred $90,000 of factory labor costs, of which $80,000 is direct labor and $10,000 is indirect labor. Actual overhead incurred was $119,000.

  Calculate what is the pressure at the siphon crown

The siphon crown is 1.2m above the water surface elevation of the reservoir and a length 10m away from the siphon entrance. If the siphon diameter is 30 cm, if the friction factor is .02, and the headless coefficient are .2 (inlet) and 1 (exit),

  What is the magnitude of the resistive force

For a huge luxury liner to move with constant velocity, its engines need to supply a forward thrust of 7.05 105 N. What is the magnitude of the resistive force

  Write a program using the class as defined

Write a program using` the class as defined below. Put the class definition in a separate header file, and put all the functions' code in a separate Resource file.

  Explain a/some pattern/s of behaviour that you have observed

Select ONE of these lessons (principles), (the standard of living depends on a country's production)and explain a/some pattern/s of behaviour that you have observed in the media (newspapers, television, radio, Business Review Weekly, The Economist, e..

  Find the mass of the stick using method of torques

We used a 100g mass hung from the 10 cm mark on a meter stick. find the mass of the stick using method of torques

  How many weeks must pass before likelihood of lake water

A lake has a water level which is used to determine if watering restrictions need to be implemented for the neighboring city. Water levels are measured on a weekly basis, and restrictions are placed if the lake level drops below 1060 ft.

  Explain how and why firms practice 3rd degree price

Explain how and why firms practice 3rd degree price discrimination. Use the handout to illustrate your answer (coupons; airlines, mobile phones).

  Find probability that the percent absorbed is more than 10

When a pesticide comes into contact with skin, a certain percentage of it is absorbed. The percentage of the pesticide that will be absorbed during a given tie period can be modeled with a lognormal distribution.

Reviews

Write a Review

 

Similar Q& A

  Determine the tensions in the cables and the reactions at a

The force F is acting on the boom ABC at C points in the direction of the unit vector 0.7071i-0.7071j and its magnitude is 10kN. The boom is supported by a ball and socket at A and cables BD and BE.

  Determine the time it takes the 20th vehicle to arrive waits

Vehicles arrive at a tollbooth according to the function h(t)= 5.2-0.2t, where h(t)is in vehicles per minute and t is in minutes. The toll booth operator processes 3 vehicles per minute.

  Describe a piece of john deere agricultural equipment

Describe a piece of John Deere agricultural equipment that utilizes GPS hardware and software. Describe how many RECs are placed on the equipment and where it is placed.

  Determine the settlements having stress

The soil properties of the clay are Cc = 0.25, Cr = 0.05, gsat = 18 kN/m 3 , for the sand gsat = 18 kN/m 3 , and the water table is 2 m below the soil surface. Determine the settlements when a stress of 100 kPa is applied by the building over an a..

  Calculate the final length and final diameter of specuman

A cylinder with a 6.0 in., diameter 12.0 in. height is put under a compresive load of 150 kips. The modulus of elasticity for this specimen is 8000 ksi and Poisson's ratio is 0.35. calculate the final length and the final diameter of this specuman..

  Determine what is the pm concentration in ug per dscm

A stack (T=550 F and P=750 mmHg) was sampled using EPA Method 5. The total gas volume that flowed through the dry gas meter was 2.785 cubic meters (at T=60 F and P=800 mmHg).The mass of particles collected was 1.50 g.

  Determine how to calculate ph of water at 25 degrees

How do you calculate pH of water at 25 degrees that contains 0.6580mg/l carbonic acid. Assume that [H+] =[HCO3-]at equilibriumand ignore the dissociation of water.

  What are the total delay and the average delay per vehicle

Assuming D/D/1 queuing, when does the initial queue clear and what are the total delay, the average delay per vehicle, longest queue length (in vehicles), and the wait time of 100th vehicle to arrive (assumin first-in-first-out)

  Determine the maximum water hammer pressure in pipeline

A gate valve is located at the end of the pipe. If the valve is closed suddenly, determine the maximum water hammer pressure that will develop in the pipeline. The water level in the reservoir is 98.4 ft above the outlet.

  Compute the new unit weight and moisture content of soil

A sample of soil was compacted into a 945 ml.laboratory mold. The mass of the compacted soil was 1850 grams and its moisture content was 13.1%. Specific gravity of solids is 2.70, Compute the moist unit weight, dry unit weight, and degree of satu..

  What is the diameter of a sphere with the volume

A tank of Compressed oxygen for flame cutting is to contain 10 kg of oxygen at a preassure of 14 MPA ( the temperature is 20 degrees Celsius). How large must be the tank volume

  What fraction of the flue gas stream would need to be bypass

The company engineer decides that this is too good, that it is not necessary to be this efficient, and proposed that part of the flue gas be bypassed around the electrostatic precipitator so that the recovery of fly ash (particulates) from the flu..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd