What will the lowest dissolved oxygen concentration

Assignment Help Civil Engineering
Reference no: EM13314262

A wastewater is discharged to a stream with a reoxygenation constant of 0.5 day-1 and a velocity of 1 m/sec. The oxygen saturation concentration in the stream is 11 mg/L. Immediately downstream of the discharge the oxygen concentration is 9 mg/L and the deoxygenation constant is 0.3 day-1. Upstream of the discharge the ultimate oxygen demand is 8 mg/L and the stream flows at 20 million gallons per day. The plant discharges a waste which has an ultimate oxygen demand of 30 mg/L and has a flow rate of 8 million gallons per day. What will the lowest dissolved oxygen concentration be downstream of the discharge and how far down the stream will it occur?

Reference no: EM13314262

Questions Cloud

What would be the reading on a barometer containing benzene : What would be the reading on a barometer containing Benzene at 20 degrees Celsius at a time when the atmospheric pressure was equivalent to 12.3 m of water
How to calculate q of the fraction of solute : Calculate q, the fraction of solute that would remain in the water under each of the following extraction conditions: Three extractions with 100 mL of ether.
Explain purpose and amount of reinforcing in concrete beams : Simply Supported Reinforced Concrete Beams - Explain the purpose and amount of reinforcing in concrete beams in relation to bending and shear and the concepts of under reinforcement, balanced reinforcement and over reinforcement.
What is theshear modulus of the sponge : A large sponge has forces of magnitude 12 N applied in oppositedirections to two opposite faces of area 42 cm^2. What is theshear modulus of the sponge
What will the lowest dissolved oxygen concentration : A wastewater is discharged to a stream with a reoxygenation constant of 0.5 day-1 and a velocity of 1 m/sec. The oxygen saturation concentration in the stream is 11 mg/L.
What are the dimensions of the image on the screen : The dimensions of the picture on a 35.0{\rm mm} color slide are x = 24.0{\rm mm} {\times}y = 36.0{\rm mm}. What are the dimensions of the image on the screen
Explain what is the change in energy : What is the change in energy, Delta E, in kilojoules per mole of hydrogen atoms for an electron transition from n=9 to n=2
Determine what force must apply at the ends to achieve : What couple moment does he exert. How much could he exert if he moved his hands to the ends so that his hands are 254 inches apart. What force must he apply at the ends to achieve the same couple moments as when he held his hands 18 inches apart.
Explain the heat generated from combustion goes to heat : Assume each of the following: the fuel has an average formula of C7H16; 15% of the heat generated from combustion goes to heat the water (the rest is lost to the surroundings); the density of the fuel is 0.78 g/mL; the initial temperature of the w..

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  How the mechanical properties of aluminum may be improved

Given that the moduli of electricity of this material are respectively 69GPa and 393 GPa plot modulus of elasticity versus the volum percent of Al2O3 in Al from 0 to 100 vol % using both upper and lower bound expressions

  What is the minimum required temperture of the boiler

The coal-fired boilder supplies 70 MW to the steam while thermal energy is rejected to a nearby lake whos average temperature is 15 C. What is the minimum required temperture of the boiler to meet the power demands of the city

  Find number of completely mixed chlorine contact chambers

Determine the number of completely mixed chlorine contact chambers each having a detention time of 30 min that would be required in a series arrangement to reduce the bacterial count of a treated effluent form 10^6 to 14.5 organisms/mL

  Explain how to determine the power output of the turbine

The water enters at 1 atm at 10 C and the flow rate through the turbine is 40 m3/s. The water is discharged from the turbine 200 m below the intake at 1 atm and the temperature of the water at the discharge is 10.2 C.

  Calculate the normal and shear stress on planes making angle

a tension member with cross-sectional area 3 in2 resists a load of 10 kips. How do you Calculate the normal and shear stress on planes making a 0, 20, 45, and 60 angle with the transverse section.

  Determine the amount of moisture removed from the air

Moist air at standard conditions is at a dry bulb temperature of 80 degree F and a relative humidity of 50%. It is cooled to 50 degree F. Use the psychromtric chart to determine: a- The energy removed from the air after it is cooled in BTU/lb of d..

  Determine what percent of the hocl is dissociated

A solution of HOCl is prepared in water by adding 15 mg HOCl to a volumetric flask, and adding water to the 1.0 L mark. The final pH is measured to be 7.0. What are the concentrations of HOCl and OCl

  Determine the smallest fprce p that should be applied

Knowing that the coefficient of static friction is 0.25 at all surfaces of contact, determine the smallest fprce P that should be applied to one of the wedges.

  Determine the flow of vehicles on the level section

rom a photograph one observes that on a level section of highway 10% of the vehicles are trucks, 90% are cars, and that there are 50 vehicles per mile of highway. The trucks travel at 40 mph, and the cars at 50 mph.

  Explain how to estimate the los at the corridor

An airport corridor is 30 ft wide. given a peak demand of 300 pedestrians per minute and an average walk speed of 3 ft/s, estimate the LOS at the corridor

  What would height be after it was consolidated into packing

A 1m thick layer of this soil is packed so that it is as loose as possible (void ratio, e_max ~= 0.9), and then it was vibrated until it was as dense as possible (void ratio, e_min ~= 0.35).

  Estimate particle size will be collected with efficiency

A cyclone is designed with an inlet width (W) of 12.0 cm and has four effective turns. The inlet gas velocity is 15.0 m/s and the particle density is 1.70 g/cm3. (a) Estimate the particle size that will be collected with 50 % efficiency.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd