Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. The current in a circuit is 1 amp. What will the current be when the voltage is increased by 50%?
2. A 10ohm resistor is connected across a 12 V battery. How much current is there through the resistor?
3. Three amperes of current are measured through a 27 ? resistor connected across a voltage source. How much voltage does the source produce?
4. How much power is dissipated by a 2.4 k resistor in series with a 12V power supply?
We have four 3-H inductances. What is the maximum inductance that can be obtained by connecting all of the inductances in series and/or parallel What is the minimum inductance
Using a slotted line, the voltage on a lossless transmission line was found to have a maximum magnitude of 1.5 V and a minimum magnitude of 0.6 V. Find the magnitude of the load's reflection coefficient 'Omega'.
MOSFET Amplier Sketch the 4-resistor bias network for an amplier with an n-channel enhancement-mode MOSFET, with R1 = 1Mohm ; R2 = 1:5Mohm ; RD = 75kohm ; Rs = 39kohm ; K = 25microA/V2 ; VDD = 10V and Vto = 1V.
Vs=310 V (Vrms=219 V) at the input of bridge rectifier Need LC filter at the output of bridge which can provide 240 V +-10V DC, with 2 A constant current. find method to find appropriate values of LC which can provide these specification.
Design a parallel resonance circuit with resonance frequency of 30kHz and bandwidth of 20kHz and plot its frequency response.
Given the starting address for the TC0 Interrupt is to become $5000. Write the assembly instruction necessary to place this ISR address into the interrupt vector table and then unmask the interrupt (assembly only).
Now assume that the doctor knows that 1 in 100 individuals with symptom G will have the rare disease, and he only orders the test when individuals have symptom G. Given that one of the doctor's patients tests positive.
A 100 W bulb takes 0.833A and a 200 W bulb takes 1.67 A from a 120V source. If the two bulb were connected across a 240 V source, what current in amperes will flow through the bulbs?
At the end, the wave totally reflects with a pi phase shift, and the reflected wave now interferes with the incident wave to yield a standing wave pattern over the line length.a) Determine the standing wave pattern for the voltage in the line.
A pacemaker is programmed to deliver pulses a certain times every minute for a patient with heart block. A 0.5µF capacitor controls the pulse discharges through a 2M resistor. One pulse is delivered every time the fully charged capacitor loses 50%
Interpreting frequency domain signal spectrum to time domain, A spectrum analyzer is connected to an unknown signal. The spectrum analyzer displays the voltage level of signals in volts vertically and frequency horizontally.
Operational amplifier - Finding the offset voltage, An operational amplifier has a gain of 20. The input voltage is 125mV and the input bias current is zero.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd