+1-415-670-9189
info@expertsmind.com
What will be the total cost per lane-mile per inch depth
Course:- Civil Engineering
Reference No.:- EM13298431




Assignment Help
Assignment Help >> Civil Engineering

For a standard lane 12-feet wide and 1 mile long, what would be the cost per-lane mile of pavement?

Cost per lane-mile per inch depth are:

Asphalt = $39,352.50

Base = $15,840.00

Subbase = $2,656.50

If an alternative base material is available for $5,791.50 per lane-mile per inch depth, to use it, the minimum depth for asphalt has to be increase to 6 inch with no change of base and subbasedepth. What will be the total cost per lane-mile per inch depth? If this design can extend the pavement life to 25 years (Normal life is 20 years), which design would you recommend?




Put your comment
 
Minimize


Ask Question & Get Answers from Experts
Browse some more (Civil Engineering) Materials
A short hollow cast iron cylinder with a wall of thickness of 1 inch. is to carry a compressive load p=150 kips. compute the required outside diameter if the working stress
In Chlorine disinfection (3-log reduction in Giardia- Cysts), determine the water pH for a contact time of 90 minutes using a chlorine concentration of 2 mg/L at 20 degrees
The concentration of toluene (CHs) in subsurface soil samples collected after an underground storage tank was removed indicated the toluene con-centration was 5 mg/kg. What
1 What is the magnitude of the reaction force at pin B in lbs? 2  What is the reaction force in the x direction at pin A from ground on member AB in lbs? 3 What is the reactio
A hazardous waste incinerator is to burn 200 Kg/h of PCB waste that is 30 % PCB and 70 % organic solvents. During testing phase, the concentration of PCB in the emission was
Ecocity has two potential sources of water supply: groundwater and a small river fed by a mountain spring. The river supports a lot of fish and other wildlife, so the citizens
Is it possible to assign valid logic levels and noise margin boundaries so that a device with the following transfer characteristic would serve as an inverter? Briefly expla
An airplane flies at a speed of 360 mph at an altitude of 5000 ft. If the boundary layers on the wing surfaces behave as those on a flat plate, estimate the extent of lamina