What will be the concentration of tce in the aqueous phase

Assignment Help Civil Engineering
Reference no: EM13315496

The dimensionless henry's constant for TCE at 25 degrees celsius is 0.4. A sealed glass vial is prepared that has an air volum of 4mL overlying an aquesous volume of 36mL. TCE is added to the aqueous phase so that initally it has an aqueous phase concentration of 100 ppb. After the system equilibrates, what will be the concentration of TCE in the aqueous phase?

Reference no: EM13315496

Questions Cloud

Design flow of cfs and design the channel section : An earthen channel will be excavated into sandy soil for which Vmax = 4.0 ft/sec, n=0.022 and the recommended m=3. The channel will have a bottom slope of 0.0011 and accommodate a design flow of 303 cfs. Design (size) the channel section.
Consider the following einf gramar for the simple calculator : Consider the following EINF gramar for the simple calculator language mentioned in class.
Find the mass of the disk : A uniform disk of radius 0.517 m and unknown mass is constrained to rotate about a perpendicular axis through its center. Find the mass of the disk
What is this temperature on the kelvin scale : The lowest outdoor temperature ever recorded on Earth was %u2212128.6 %u25E6F, recorded at Vostok Station, Antarctica, in 1983. What is this temperature on the Kelvin scale
What will be the concentration of tce in the aqueous phase : The dimensionless henry's constant for TCE at 25 degrees celsius is 0.4. A sealed glass vial is prepared that has an air volum of 4mL overlying an aquesous volume of 36mL.
Find the vertical component of the force : A non-uniform beam of length 4.41m and weight 1.02kg makes an angle of 25.2 with the horizontal. Find the vertical component of the force exerted on the beam by the pivot
Determine what is the intrinsic permeability of coarse sand : The hydraulic conductivity of a coarse sand was measured in the laboratory permeameter and found to be 1.03x10^-2 cm/s at 25 degrees C. What is the intrinsic permeability
How many tons of coarse aggregate will be required to fill : how many tons of coarse aggregate will be required to fill a trench 5 ft deep, 3 feet wide and 300 feet long. the coarse aggregate unit weight equals 93.6 lb per cu ft.
What is the induced emf in the entire solenoid : A solenoid of length 5.0 cm and diameter 0.87 cm is wound with 162 turns per cm. The current is decreasing at a rate of 38.0 A/s. What is the induced emf in the entire solenoid

Reviews

Write a Review

Civil Engineering Questions & Answers

  How to express the variables as a dimensionless group

The velocity of propagation, c of surface waves is assumed to depend on the water depth, y, the water density, and the acceleration due to gravity, g. Express these variables as a dimensionless group.

  Find bod reaction rate constant of a municipal waste water

If the BOD5 of a municipal wastewater is 310 mg/L and the BODU is 340 mg/L, determine the BOD reaction rate constant (base e). What would be the 3 day 30°C BOD Assume, temperature coefficient = 1.047.

  Falling-head permeability test

A falling-head permeability test was carried out on a clay soil of diameter 100 mm and length 150 mm. In 4 minutes the head in the standpipe of diameter 5mm dropped from 680 to 350 mm.

  Force on block problem

The block is acted by its weight W=200 lb, a horizontal force Q=600 lb, and the pressure P exerted by the inclined plane. The resultant R of these forces is up and parallel to the inclined thereby sliding the block up it. Determine P and R.

  Usage rates if the community has a declining growth rate

Determine how many years from now the consumption will reach its design capacity with current usage rates if the community has a declining growth rate.

  Oxidization of ammonia during nitirification

what is the final dissolved oxygen concentration (in mg/L) in the waste lagoon after all of the ammonium (NH4 + ) is converted to nitrate? Recall that 4.57 mg of O 2 is need per mg of ammonium (as N) oxidized during nitirification. After all of the..

  Determine the depth that will result upstream during design

The design discharge is 9.5 m^3/sec and the inlet will be submerged but not the outlet. Determine the depth that will result upstream (above the invert) during the design flood event.

  How would structure a portion of an aviation safety program

How would you structure a portion of an Aviation Safety program for a commercial airline or government agency. Briefly describe one or two safety problems and why it is a serious safety problem.

  Determine the moisture content and overall specific weight

A sample of argillaceous soil with a volume of 1x10-3 m3 and a mass of 1.762 kg, after oven dried, has a mass of 1.368 kg. The relative density of the grains is equal to 2.69. Determine, for the sample in its original condition

  Determine the force in chains ac and ad during the lift

the 3.5mg engine is suspended from a 500 kg spreader beam and hoisted by a crane which gives it an acceleration of 4m/s^2 when it has a velocity of 2m/s. determine the force in chains AC and AD during the lift.

  Verify that there are no outliers in the sample data

The measurements of the nominal shear strength (in kN) for a sample of 15 prestressed concrete beams are as follows: 580 400 428 825 850 875 920 550 575 750 636 360 590 735 950

  What is the ratio of the strain energy u1 in the tube

a thin walled circular tube and a solid circular bar of the same material are subjected to torsion. the tube and the bar have the same cross-sectional area and the same length.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd