What synchronous reactance and armature resistance in ohms

Assignment Help Electrical Engineering
Reference no: EM13967396

1. Assume that the generator's field current is adjusted so that the generator supplies rated voltage at the rated load current and power factor. If the field current and the magnitude of the load current are held constant, how will the terminal voltage change as the load power factor varies from 0.85 PF lagging to 0.85 PF leading? Make a plot of the terminal voltage versus the impedance angle of the load being supplied by this generator.

2. A 100-MVA 11.5-kV 0.8-PF-lagging 50-Hz two-pole Y-connected synchronous generator has a per-unit synchronous reactance of 0.8 and a per-unit armature resistance of 0.012.

(a) What are its synchronous reactance and armature resistance in ohms?

(b) What is the magnitude of the internal generated voltage EA at the rated conditions? What is its torque angle d at these conditions?

(c) Ignoring losses in this generator, what torque must be applied to its shaft by the prime mover at full load?

Reference no: EM13967396

Questions Cloud

Describe the steps of a generic feedback cycle : Describe the steps of a generic feedback cycle. Make the feedback steps specific to consulting and explain your revisions.
What is the output torque of this motor : A 480-V, 60 Hz, six-pole synchronous motor draws 80 A from the line at unity power factor and full load. What is the output torque of this motor? Express the answer both in newton-meters and in pound- feet.
This consists of one or two paragraphs with title : This consists of one or two paragraphs with title on what you propose to write about in your term paper. The term paper topic must be relevant to Astronomy involving any aspect of stars, planetary systems, galaxies, cosmology, etc.
Trade-offs between inputs for the productivity improvements : Analyze the trade-offs between inputs for the productivity improvements - analyze the advantages and disadvantages of global sourcing versus producing in the U.S and describe a product or service of a specific low-labor-cost country as an example.
What synchronous reactance and armature resistance in ohms : A 100-MVA 11.5-kV 0.8-PF-lagging 50-Hz two-pole Y-connected synchronous generator has a per-unit synchronous reactance of 0.8 and a per-unit armature resistance of 0.012. What are its synchronous reactance and armature resistance in ohms?
Who is the intended audience for this product : Is thereequality of status or importance between the sender and the receiver?
How zappos connects to customers through social media : Create a third report of 1 -2 pages on how Zappos connects to customers through social media, such as Pinterest and Instagram, to achieve customer loyalty
Monopoly versus perfectly competitive equilibrium : Big Apple Music, Inc., enjoys an exclusive copyright on music written and produced by the Fab Four, a legendary British rock group. Total and marginal revenues for the group's CDs are given by the following relations:
Briefly summarize the article and critique the major points : Briefly summarize the article and critique the major points. This is not just a report, it is a critical analysis of the article. Article- Evaluating the Employees You Can't See by Keith Ferrazzi.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the linear gain at the edge of the stop band

For a low pass Chebyshev Type I with a pass band edge gain = -2 dB and a stop band edge gain = -40 dB, find the linear gain at the edge of the stop band.

  Calculate the concentration of electrons and holes

An unknown semiconductor has a bandgap of 1.1eV and Nc = Nv. It is doped with 10^15 cm-3 donors where the donors fully ionized. Given that EF is 0.25 eV below Ec, calculate the concentration of electrons and holes in the semiconductor at 300 K and..

  Blocks the dc and is relatively high impedance

Choose the best answer for what a DC blocking or coupling capacitor does, assume the capacitor value is chosen to be too small.                  Blocks the DC and is relatively high impedance to the AC voltage.      Blocks only the AC voltage going ..

  Find the heat energy generated by the amplifier

The power amplifier in a home theater amplifier has an output power of 200 watts. Assuming a Class B amplifier with the maximum theoretical efficiency is used, find the DC power delivered to the amplifier.

  How to control shopping center parking lot lighting system

A control system is needed to control a small shopping center parking lot lighting system and the exterior lighting for the building. The design specifications require that the parking lot lighting and the exterior lighting turn on at dusk automat..

  How much charge passes through a cross section

the ends of a length of wire are labeleda and b. If the current in the wire is iab = -3A, are electrons moving toward a or b? How much charge passes through a cross section of the wire in 3 seconds?

  Describe is installation of the pump justified

However, the pump requires 60 W of parasitic power to operate continuously. Is installation of the pump justified. Explain. At what value of parasitic power does the addition of the pump become unjustified.

  Determine what is the turbine isentropic efficiency

A jet engine is modeled as a serial combination of a compressor, an adiabatic constant pressure combustor, and a turbine. Air (considered to have a variable specific heat) is compressed through a compression pressure ratio of 8.25:1

  Evaluate the power that is dissipated by the load resistor

The parameters of a certain transmission line operating at ω = 6×108 rad/s are L = 0.35μH/m, C = 40 pF/m, G = 75 μS/m, and R = 17 Ω/m => α=0.0943 Np/m, β=2.2467 rad/m, λ=2.7966 m, Z0 =93.623-j3.6368

  What are the impedance and the component value of the load

A balanced, three-phase, Y-connected source has a line voltage of 440 Vrms. The source frequency is 60 Hz. The balanced, three-phase loads have the following characteristics: Zy1: P1 = 15 kW and Q1 = +18 kVAR Z?2: |S2|=21 kVA and PF2 = 0.500 laggin..

  Find the change in currents using small signal model

Find the change in currents due to change of voltage by (a) 5mv, (b) -10mv, (c) 15mv using small signal model and exponential model of diode with n= 1 and biased at 2mA.

  Similar to my last question i broke these into multiple

similar to my last question. i broke these into multiple parts but tried to keep all of the information together.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd