What major differences would you expect if the water supply

Assignment Help Civil Engineering
Reference no: EM13545662

A large stream flowing through a highly industrialized area must serve as the source of a community's water supply. The turbidity of the water ranges from 30 to 60 NTU, alkalinity exceeds 100 mg/L, hardness is about 50 mg/L as CaCO3, and the water also contains regulated synthetic organic compounds resulting from industrial discharges.

(a)What major differences would you expect if the water supply source had been groundwater?

Reference no: EM13545662

Questions Cloud

A root of the linear portion of the stress strain relation : A 32mm rebar with a guage length of 200mm was subjected to tension to fracture according to ASTM E-8 method. The load and deformation data were as shown in table below.
Will the quantity of coarse aggregate incease decrease : A concrete mix with a 3in slump, w/c ratio of .5, and sand with a fineness modulus of 2.4 contains 1700lb/yd3 of coarse aggregate. Compute the required weight of coarse aggregate per cubic yard.
How you will place the bars and calculate the location : Concrete cover on both sides. Sketch how you will place the bars and calculate the location of the effective depth. Place as many bars in the lower layers as possible.
How many cubic yards of aggregate must be ordered for a road : How many cubic yards of aggregate must be ordered for a road base 16 inches thick and 2000 feet long with a top width of 30 ft, if the side slopes are one on one, or 45 degree?
What major differences would you expect if the water supply : A large stream flowing through a highly industrialized area must serve as the source of a community's water supply. The turbidity of the water ranges from 30 to 60 NTU, alkalinity exceeds 100 mg/L.
Determine the coliform concentration at the beach : Determine the coliform concentration at the beach. (assume that the current behaves as a plug flow reactor and that the wastewater is completely mixed in the current at the discharge point.
What is the discharge of each hole : A water of 20 c temprature pupped at 75 kpa to a perforated pipe 5 cm dia. contain 10 hole with the same diameter. the distance between two adjacent hole is 20 cm. what is the discharge of each hole?
Use the conveyance method to verify the results : A drainage channel had a cross section that may be approximated as a trapezoidal section with a bottom width of 15 feet and a side slope of 1.5H:1V. If the channel drops 2.5 feet per mile.
Determine the size of the watershed in acres and then : The 1-hr UH in the table was recorded for a particular watershed. Determine the size of the watershed in acres and then convert the 1-hr UH into a 3-hr UH for the watershed.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Estimate total cost and cost per linear foot for furnushing

estimate the total cost and cost per linear foot for furnushing and driving steel-sheet piling for construction of the basement of a building, 150 by 240 ft. the piles will be 22 in. wide, 18 ft. long, and weigh 40.3 Ib/Lin ft.

  Water at 20 c is proposed to be is siphoned from a

water at 20 c is proposed to be is siphoned from a reservoir as shown. assume no losses. for d 10 cm and d 16 cm

  Determine the radial and transverse components

Starting from rest, the boy runs outward in the radialdirection from the center of the platform with a constantacceleration of 0.5 m/s2. If the platform is rotating ata constant rat

  Sketch clearly the velocity and shear stress profiles

A film of newtonian liquid folws down the outside surface of avertical cylinder of radius R. the flow is steady, laminar andthe thickness of the film is constant.

  What is the length of steel tape having cross-sectional area

What is the length of a 200 ft. steel tape having a cross-sectional area of 0.004in2 and a modulus of elasticity of 30,000,000 lb/in2 that is standardized at a tension of 20 lb and a temperature of 68°F

  Going from west to east on the same section of the road

A section of highway is 18 km long. A bus going fromeast to west on this road climbs for 6 minutes at one speed, levelsoff for 6 minutes at a second speed and descends for 6 minutes at athird speed. Going from west to east on the same section ofthe r..

  What point defects are possible for mgo as impurity in al2o3

What point defects are possible for MgO as an impurity in Al2O3. How many Mg2+ ions must be added to form each of these defects.

  Compute original length if deformation is totally elastic

A cylindrical specimen of a metal alloy is stressed in compression. if its original and final diameters are 40.00mm and 40.10mm respectively, and its final length is 120.00mm, compute its original length (L1) if the deformation is totally elastic.

  Calculate and plot the distribution of total and stresses

A borehole at a site reveals a soil profile comprising 6 m deep fine sand layer overlying a 9 m thick clay layer, which in turn overlies weathered bedrock. The groundwater table is located at a depth of 4 m from the ground surface.

  Determine what is the shear stress at the pipe wall

Stream with a specific weight of 38 N/m^3 is flowing with a velocity of 35 m/s through a circular pipe with f=0.0154. What is the shear stress at the pipe wall

  Why would we use prestressed concrete to build

How we can find the applicaition of internal force in civil? mean an appication for the internal force in the civil

  What is the lowest pressure expected in the prototype

A dam spillway is to be tested using kinematic similitude (Froude scaling) with a 1:20-scale model. The model flow has an average velocity of 0.7 m/s and a flow rate of 0.06 m3/s.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd