Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Silicon, originally intrinsic, is doped with 4*10^16 /cm^3 of arsenic atoms at room temperature.a) What proportion of the silicon atoms have been replaced by arsenic atoms?b) What is the thermally generated density of electrons and holes?c) What is the bound ionic charge density in Coulombs/cm^3?
a) What are the FIVE requirements for synchronizing the alternator tot he grid b) What should happen once the synchronous alternator is synchronized At that very instant, what should happen if the above five conditions are met
Assume all the capacitors in the circuit below were discharged prior to assembly. The capacitors, resistors, and voltage sources are then arranged as shown in the circuit below. The circuit is then allowed to stabilize.
A charged 100-pf capacitor has initial voltage across it of 10V. a 100kohm resistor is suddenly connected across the capacitor (at t=0) to discharge it. What is the magnitude of the instantaneous current at 20 usec?
Design and implement an algorithm that determines whether or not a given array of elements, list1, is completely contained within another given array of elements, list2. Consider two different scenarios: 1) both arrays are sorted; 2) both arrays a..
An analog system has a bandwidth of 10 MHz, a photodetector of = 0.5 A/W and ID = 1 nA, and a signal to noise ratio (SNR) of 30 dB. The receiver's temperature is 270 C and the load resistance is 50 .
Refer to the Wheatstone Bridge diagram. If R1=1ohm, R2=111ohm, Runknown= 1ohm, R3 is set at 1Kohm, and the battery is 9V:What is the current flowing through the galvanometerohm Use 60ohm for the internal galvanometer resistance in calculations.
What is the difference between multiplexing and multiple access?
A three-phase, 5kVA, 208 V, four-pole, 60Hz, Y-connected synchronous generator has negligible stator winding resistance and a synchronous reactance of 8 ohms per phase at rated terminal voltage.
In transformer designs, often you can find an air gap in the core. In all the electric machines, there is an air gap between the stator and rotor. In both cases, flux will go through both core material and the air gap.
Two three-phase loads are y-connected across a 300 Volt three phase line. One load draws 10kW at a p.f. of 0.9 leading, and the second load draws 8kW at a p.f. of 0.6 lagging. V(line-neutral)=300V/sqrt(3)=173.21V
Given that the number of charges measured at t1 is n1 = 2.20×10^19, and the number of charges measured at t2 is n2 = 7.15×10^19. Find the current flow if the time interval between t1 and t2 is 2 s.
The resistance of the field circuit of a shunt-excited dc generator is 200. When the output power of the generator is 100kW, the terminal voltage is 500V and the generated e.m.f is 525V.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd