What is the undrained shear strength of the clat in kpa

Assignment Help Civil Engineering
Reference no: EM13560253

1.A saturated clay deposit is vane-tested in-situ. A torque of 30Nm is required to shear the clat. The vane is 40mm wide by 100mm long.

What is the undrained shear strength of the clat in kPa?

2.What is the dry unit weight, the saturated unit weight, and the buoyant unit weight, of a soil having a ratio of 0.5 and a value of Gs of 2.7?

Reference no: EM13560253

Questions Cloud

How much will it cost for one 15 minute episode of heating : A room 4x5x6 meter is heated by a baseboard resistance heater. We want the heater to raise the room temperature from 7 to 23 deg C in 15 minutes. There are no heat losses from the room, and specific heat may be assumed constant. Power costs 15 cents ..
What is the volume of the solids in it : A frictionless piston-cylinder contains 2kg of nitrogen at 100 kPa absolute and 300 deg K. The system is compressed polyprotically at a 1.4 exponent (n) until the nitrogen reaches a final temperature of 360 deg K.
Discuss specific strategies blake : Discuss specific strategies Blake uses in critique of society in "London" and two of his other poems.
Apply the three internal analysis frameworks-swot analysis : Apply the three internal analysis frameworks-SWOT analysis
What is the undrained shear strength of the clat in kpa : A saturated clay deposit is vane-tested in-situ. A torque of 30Nm is required to shear the clat. The vane is 40mm wide by 100mm long.What is the undrained shear strength of the clat in kPa?
A rope-jumping rhyme : Who is "The Chorus Line: A Rope-Jumping Rhyme" addressed to? How is this chorus connected to Atwood's theme?
Is imc campaign centred : Is IMC campaign centred
What is the effective vertical stress 12m below the water : A river is 6m deep. The riverbed material has a saturated unit weight of 19.5kN/m3. What is the effective vertical stress 12m below the water surface?
Draw to scale the streakline path-line of the particle : For a given hypothetical flow, the velocity from time t=0 to t=5 seconds was u=2 m/s , v=0. Then, from time t=5 s to t=10 s, the velocity was u=+3 m/s, v=-4 m/s. A dye streak was started at a point in the flow field at time t=0

Reviews

Write a Review

Civil Engineering Questions & Answers

  Evaluate the rates of linear and angular deformation

Consider the pressure-driven flow between stationary parallel plates separated by distance 2b. Coordinate y is measured from the channel centerline. The velocity field is given by u=u max(1-(y/b)^2).

  Determine the volume of soil that must be excavated

Soil have a void ratio of 0.68 as it exists in a borrow pit is to be excavated and transported to a fill site where it will be compacted to a void ratio of 0.45. The volume of fill required is 2500 m^3.

  Draw the approximate positions of the water table for

For a cross section of a slope through a jointed rock mass, draw the approximate positions of the water table for the following conditions. (K = relative permeability)

  What should be mixture ratio of pure water to river water

A river with 400 ppm of salts (a conservative substance) and an upstream flow of 25 m^3/s receives an agricultural discharge of 5.0 m^3/s carrying 2000 mg/L of salts.

  Determine the magnitude of f2 which will cause the reaction

Determine the magnitude of F2 which will cause the reaction Cy at the bearing C to beequal to zero. The bearings are in proper alignment and exertonly force reactions on the rod. Set F1 = 550 lb.

  What are dtm and dem what is the difference between them

If the stage of a stream increases by 40% and the slope of the water surface becomes half of its original slope, then what will be changes in discharge of the stream?

  Calculate the required plate area and the number of plates

An Electrostatic Precipitator must treat 500,000 acfm with 99% efficiency. Assuming an effective drift velocity of 0.4 ft/sec, calculate the required plate area in ft^2, and the number of plates if each is 20 ft tall by 10 ft long, and there are 4..

  Estimate the required removal efficiency of particles in esp

An electrostatic precipitator (ESP) is being designed to collect flue gas particles at a power plant. The following information has been collected: electric field intensity = 100,000 V/m, and average particle charge = 0.30 fC (1 fC = 10-15 C).

  What do will result if the concentration of waste is reduced

The discharge from a sugar beet plant causes the DO at the critical point to fall to 4.0 mg/L. The stream has a negligible BOD and the initial deficit after the river and wastewater have mixed is zero.

  Will the ship take more or less draft when steaming

A 245 m ship has a displacement of 3x10^8N,and the area defined by the waterline is 3550m^2. will the ship take more or less draft when steaming from salt water to fresh water How much will it settle or rise

  Ompare the ratio of kinetic energy to the potential energy

If a unit mass of groundwater accelerates from rest to an average linear velocity of 1 m per year and climbs a vertical distance of 1 m, compare the ratio of kinetic energy to the potential energy of the unit of groundwater.

  Derive equation that would allow for the direct calculation

A completely mixed flow reactor, with a volume of V and a flow rate of Q, has a zero-order reaction, dA/dt = k, where A is the material being produced and k is the rate constant.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd