What is the tension in the cables

Assignment Help Physics
Reference no: EM1344907

Q. A 17g rifle bullet travelling 220 m/s buries itself in a 3.90 kg pendulum hanging on a 3m long string, which makes the pendulum swing upward in an arc. Find out the vertical and horizontal components of the pendulum's displacement.

Q. A 22kg loudspeaker is suspended 3M below the ceiling by two cables that are each 20 degrees from vertical. What is the tension in the cables?

Reference no: EM1344907

Questions Cloud

How much work is necessary to put the bag on a shelf : A cable is used to raise a 29kg urn from an underwater archeological site. There is a 21 N drag force from the water as the urn is raised at a constant speed.
Illustrate what would be the size of resulting deadweight : Illustrate what would be the size of the resulting deadweight loss relative to the competitive outcome.
Runnig test cases on same piece of code : Why four people must waste their time looking for faults when one person can run test cases on same piece of code. How do you respond?
What is the minimum force essential to make the crate : A sphere consists of a solid wooden ball of uniform density 800 and radius 0.20 and is covered with a thin coating of lead foil with area density 20.
What is the tension in the cables : A 17g rifle bullet travelling 220 m/s buries itself in a 3.90 kg pendulum hanging on a 3m long string, which makes the pendulum swing upward in an arc. Find out the vertical and horizontal components of the pendulum's displacement.
Illustrate what type of unemployment will then occur : illustrate what type of unemployment will then occur. What is the natural rate of unemployment.
Find the actual dollar value of investment : Mario just invested 12K into an interest bearing account that yields 11.0% Inflation is 6.6%. Find the actual dollar value of Mario's investment be after nine years
What length would a force of 100 n stretch it : On a dry day, just after washing your hair to remove natural oils and drying it in detail, run a plastic comb through it. Small bits of paper will be attracted to the comb. Describe why.
Sketching flowchart for people all in different departments : Sketch a document flowchart to depict each of the scenarios given below: Three people, all in different departments, look at the same document before it is eventually filed in a fourth department.

Reviews

Write a Review

Physics Questions & Answers

  Direction of the surface winds

Direction of the surface winds What is the expected composition

  Calculate this angular speed in rad/s and rev/min

What would be the potential difference VC - VB across the thin resistor if the battery emf is 4.00 volts? Suppose that the electric field in the thick wires is very small (so that the potential differences along the thick wires are negligible)

  Find out the electric flux through the bottom of the car

A block of weight W can slide on a horizontal surface. A force of W/n1 is applied to the right that causes the block to accelerate with acceleration equal to g/n2. g is the acceleration by reason of gravity. If the coefficient of kinetic friction is ..

  What is the magnitude of the average induced emf

The coil is flipped so its plane is vertical to the magnetic field in 0.050 s. What is the magnitude of the average induced emf.

  What average force athletes legs apply on a ground

What average force athletes legs apply on a ground

  What will transform in properties of the black hole

What will transform in terms of the observable properties of the black hole as this process continues

  The coefficient of volume expansion of coffee

The coefficient of volume expansion of coffee is the same as that of water. How much coffee (in cubic meters) has spilled out of the beaker.

  What is coefficient of kinetic friction

What is coefficient of kinetic friction

  Clarify what the boundary conditions were

What is the flux of Zn moving down the rod? Write down all your assumptions (hint: you will need to look up the density of copper. You do not need to account for the variation in density with alloy composition). Clarify what the boundary conditions w..

  Polymer diffusion and calibration of an optical tweezer

Polymer diffusion and Calibration of an optical tweezer

  What is the largest value v

A stone of mass 0.31 kg is tied to a string of length 0.85 m and is swung in the horizontal circle with speed v. The string has a breaking-point force of 90 N. What is the largest value v can have without string breaking.

  How much work is done lifting the car

What is force necessary on one end of apparatus in order to lift the car? How much work is done lifting the car?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd