Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Repeat Sample Problem 10.4, except that the safety factor is 10.
Problem 10.4
A double-threaded Acme stub screw of 2-in. major diameter is used in a jack having a plain thrust collar of 2.75-in. mean diameter. Coefficients of running friction are estimated as 0.10 for the collar and 0.11 for the screw.
(a) Determine the pitch, lead, thread depth, mean pitch diameter, and helix angle of the screw.
(b) Estimate the starting torque for raising and for lowering a 3500-lb load.
(c) If the screw is lifting a 3500-lb load at the rate of 4 ft/min, what is the screw rpm? What is the efficiency of the jack under this steady-state condition?
(d) Would the screw overhaul if a ball thrust bearing (of negligible friction) were used in place of the plain thrust collar?
a 1.5 hp motor is operarating in a room with air t of 20 c. the motor has an efficency of 78. the motor gives off heat
A thin-walled cylindrical pressure vessel is capped at the end and is subjected to an internal pressure (p). The inside diameter of the vessel is 6 ft and the wall thickness is 1.5 inch. The vessel is made of steel with tensile yield strength and com..
the 150-lb man lies against the cushion for which the coefficient of static friction is mu s 0.5. determine the
If the drag coefficient for the wings was 0.020 (based on the planform area), determine the ratio of the drag from the wire bracing to that from the wings.
an isentropic steam turbine processes 5kgs of steam at 4mpa. the majority of this steam is exhausted at 50kpa and 100
A pump operating at steady state receives saturated liquid water at 508C with a mass flow rate of 20 kg/s. The pressure of the water at the pump exit is 1 MPa. If the pump operates with negligible internal irreversibilities and negligible changes ..
Confirm the above result by computing the total thermal resistance per unit length of tube for a 10-mm-diameter tube having the following insulation thicknesses: 0, 2, 5, 10, 20, and 40 mm. The insulation is composed of cellular glass, and the out..
a fan drawing electricity at a rate of 1.5 kw is located within a well insulated 60 cubic meter rigid enclosure filled
if the force exerted on cable ab by the motor is f 100t32 n where t is in seconds determine the 50-kg crates velocity
Determine the required wing area for a 1350-kg airplane to cruise at 125 km/h if the airfoil is set at an angle of attack of 2.5°. The airfoil has the characteristics shown in Fig. 17.11. The cruise altitude is 5000 m in the standard atmosphere.
Consider two closely coiled helical springs, one made of steel, the other of copper, each 0.01m in wire diameter, one fitting with in the other. Each has an identical number of coils, n=20, and ends constrained to deflect the same amount.
Find the inertial velocities of points A and B if the rotor is spinning at 10 rad/s while the gimbal rotates about the vertical axis at 2 rad/s. Express your answer as components in an intermediate frame fixed to the gimbal but not spinning with t..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd