What is the percent volatile matter in the sample

Assignment Help Civil Engineering
Reference no: EM13536813

A suspended solids analysis is run on a sample. The tare mass of the crucible and filter is 55.3520 g. A sample of 260 mL is then filtered and the residue dried to constant mass at 103 degrees C. The constant mass of the crucible, filter, and the residue is 55.3890 g. The residue is then decomposed at 600 degrees C to drive off the volatile matter. Assume that the filter does not decompose at this temperature. After decomposition, the constant weight of the crucible and the residue was again determined and was found to be equal to 30.3415 g. What is the percent volatile matter in the sample?

Reference no: EM13536813

Questions Cloud

Give an example for a project/survey work where gps : A fluid flows into a plug flow reactor of volume, V, with volumetric flow rate, Q. Inflow contains species A and B and concentrations A0 and B0. Within reactor, species A undergoes first order reaction producing
Necessary to build a formal organizational structure : Why is differentiation necessary to build a formal organizational structure? Is differentiation limited to large organizations? How is the concept of span of control related to both integration and differentiation?
Assignment and understands the content : Please have Carlos Holmes as my expert for this ongoing assignment, Carlos has been my expert for this assignment and understands the content.
Theories is least relevant to merit pay : 1. Which of the following theories is least relevant to merit pay?
What is the percent volatile matter in the sample : A suspended solids analysis is run on a sample. The tare mass of the crucible and filter is 55.3520 g. A sample of 260 mL is then filtered and the residue dried to constant mass at 103 degrees C
Provide private information on u.s citizens : Research Websites and other technologies that provide private information on U.S. citizens.
Determine the reactive torques ta and tb : A uniformly tapered bronze tube AB of circular cross section and length L=1200mm is fixed at ends A and B, as shown in Figure 5. The outside diameters at end A is Da=60mm and Db=100 mm at B.
What to do about the dead/live percentages : Provide a reasonable design for a 99% efficient ESP treating 7500 m^3/min of gas. The particles have an effective drift velocity of 10.0 cm/s.
What products or services of the company : What products or services of the company are you analyzing?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the increase in vertical stress at 2m below ground

Three parallel line loads of 500kN/m are applied at ground level in a straight line 4.0m apart. Determine the increase in vertical stress at 2.0m below ground level beneath the middle load.

  What horizontal force on each lower bar is necessary to keep

A third similar bar is placed on the other two in the groove between them. Neglecting friction, what horizontal force on each lower bar is necessary to keep them together.

  Determine what length of new pipe is needed

a buried horizontal concrete pipe (n=0.012) of unknown length needs to be replaces. the length is not known because the original plans for the pipeline route have been lost. the pressure head drop along the segment that needs to be replaced is 29...

  Determine the speed with which b must walk toward a

Swimmer A immediately starts walking toward B at a speed of 2ft/s relative to the raft. Knowing that the raft weighs 300 lb, determine (a) the speed of the raft if B does not move, (b) the speed with which B must walk toward A

  What is the pressure at the leading edge

When an airplane is flying 200mph at 5000-ft altitude in standardatmosphere, the air velocity at a certain point on the wing is 273mph relative to the airplane. What suction pressure is developed onthe wing at that point? What is the pressure at the ..

  Determine how much oil is recovered by the weight

A separator accepts waste oil at 70% oil and 30% water by weight. The top product stream is pure oil while the bottom underflow contains 10% oil. If a flow of 20 gal/min is fed to the tank, how much oil is recovered

  Using present worth analysis which process should b selected

The operating cost will be $10,000 per quarter with a salvage value of $25,000 after its 2-year life. Process B will have a first cost of $250,000, an operating cost of $15,000 per quarter and a $40,000 salvage value after its 4-year life.

  What is its depth in the 18 inch diamenter pipeline

Sewage flows through a 12" diameter pipeline then through an 18" diamenter pipeline. The flow is the same (unknown) value in each pipe, and the slope is the same (unknown) contant value for both pipes.

  Determine the values of stress and the change in thickness

A rectangular steel plate with thickness t=0.625 inches is subjected to normal stresses sigma x and sigma y.The strain in the x direction is known to be 0.00065 and the strain in the y direction is known to be 0.0004.

  Estimate the vertical hydraulic conductivity using the heads

Write Darcy's equation in 2-D. There are three piezometers in an unconfined sand aquifer as shown below. The head measurements at A = 104.56 ft, B = 104.53 ft, C = 103.42 ft. The rate of recharge here is estimated to be 1.25 ft/yr.

  Determine the magnitude of the cars acceleration

If the car passes point A with a speed of 20m/s and begins to increase its speed at a constant rate of At=0.5m/s^2, determine the magnitude of the car's acceleration when s=100m and x=0.

  Determine what is the gage pressure below the liquid surface

A liquid has the peculiar property that its mass density increases linearly with depth according to the expression p = p_water (1+0.01d) where d is the depth below the liquid surface in meters.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd