Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. Steam enters a turbine at 3 MPa, 450?C, expands in a reversible adiabatic process, and exhausts at 50 kPa. Changes in kinetic and potential energies between the inlet and the exit of the turbine are small. The power output of the turbine is 800 kW. What is the mass flow rate of steam through the turbine?
2. The exit nozzle in a jet engine receives air at 1200 K, 150 kPa with negligible kinetic energy. The exit pressure is 80 kPa, and the process is reversible and adiabatic. Use constant specific heat at 300 K to find the exit velocity.
The point of dicharge is 5 m abovethe floor, and friction losses in the 50 mm pipe from the resevoirto the tower amount to 2.5 J/kg. At what height in the resevoirmust the water level be kept if the pump can deliver only 0.1kW
Draw the shear and moment Diagram for a beam that is 10 feet long, supported on the left end by a roler, and the right end by a pin, and has a 1000 lb load placed in the center i.e at 5 feet.
For satisfactory operation, the static pressure at the pump inlet must not be lower than -6 m of water gage. Determine the smallest standard commercial pipe that will give the required performance.
what are the interface design boundaries and issues for the design and installation of a new toilet for a building
The saturation concentration for the drop is 9.20 mg/L. If, after falling for two seconds, the droplet has an oxygen concentration of 3.20 mg/L, how long must the droplet fall (from the start of the fall) to achieve a concentration of 8.20 mg/L
In trigonometric leveling from point A to point B, the slope distance and the zenith angle measured in A were 2504.897 m and 85o08'54". At B, these measurements were 2504.891 m and 94o52'10" respectively.
Steam flows steadily through an adiabatic turbine. Theinlet conditions are 10 MPa, 450 C and 80 m/s. and the exitconditions are 10 kPa, 92% quality at 50 m/s.
The system comes to equilibrium. Find the final temperature and the work done by the air in the process and plot the process P-V diagram.
A customer estimates that he is getting 30 cubic yards (loose) of gypsum in his scraper. Determine the percent overload if the load estimate is correct. The maximum load capacity of the scraper is 84,000 pounds.
An object weighs 289.2N in air and 186.9N in oil of specific gravity is 0.75 find its volume and relative denesity
The steel chisel has a diameter of 0.5 in. and a length of 10 in. It is struck by a hammer that weighs 3 lb, and at the instant of impact it is moving at 12 ft/s.
They completed the installation when the temperature was 20 degrees Celsius. When the temperature rose to 25 degrees Celsius, the rail buckled into an isosceles triangle because they had not left an expansion gap.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd