What is the gain and offset of this filter-buffer stage

Assignment Help Electrical Engineering
Reference no: EM131384510

Several DC measurements are made on a signal path that contains a filter and a buffer amplifier. At input levels of 1 and 3 V, the output was found to be 1.02 and 3.33 V, respectively. Assuming linear behavior, what is the gain and offset of this filter-buffer stage?

Reference no: EM131384510

Questions Cloud

What is the rms noise voltage at the rc fi lter output : If the we decrease the capacitor value to 2.2 μF, what is the RMS noise voltage at the RC fi lter output?
What is the size of the uncalibrated error : Using the setup and results of Problem 5.14, what is the calibrated level when a 2.13 V level is measured at the filter-buffer output? What is the size of the uncalibrated error?
What assumptions are necessary to perform given test : Can you conclude that the variances of the breaking strengths of natural and synthetic fibers are different? Use a level of significance α of 0.05. What assumptions are necessary to perform this test?
Compute the range and variance : Find the mean, median, and mode of the processing times. Interpret the differences between them.- Compute the range, variance, and standard deviation of the processing times and interpret them.
What is the gain and offset of this filter-buffer stage : Several DC measurements are made on a signal path that contains a filter and a buffer amplifier. At input levels of 1 and 3 V, the output was found to be 1.02 and 3.33 V, respectively. Assuming linear behavior, what is the gain and offset of this ..
Discuss about the post given below : Facts: the most relevant legal facts, often called the key facts, are those facts that pose a question about their legal significance because they seem to establish the elements of an applicable rule of law.Procedural history: the procedural histo..
Find a confidence interval for proportion that uses airline : Find a point estimate of the proportion of the market that uses this particular airline.- Find a 95% confidence interval for the proportion that uses this airline.
Estimate the output noise voltage spectral density : The variation in the output signal of a DUT is 1 mV RMS. Assume that the DUT's output follows a first-order frequency response and has a 3-dB bandwidth of 100 Hz. Estimate the output noise voltage spectral density
Find confidence interval for the difference in proportion : Find a 90% confidence interval for the difference in the proportion of people who prefer the stipulated product before and after the advertising campaign.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is maximum voltage if current is required to be bigger

A 50-cm-long copper wire with a cross-sectional area 1.2286x10^-10 m^2 is used to connect a voltage source and a device. What is the maximum voltage if the current is required to be not bigger than 5A

  Find the developed power and power lost in ra

A shunt dc motor has RA= .1 ohmn and VT = 440 V. For an output power of 50 hp, we have nm=1500 rpm and IA = 103 A. The field current remains constant for all parts of this problem.

  Why are several pilot channels monitored in is-95 when

why are several pilot channels monitored in is-95? when does a pilot channel from a base station move from an active

  Design an active first order low pass filter

Use a capacitor, a resistor and an operational amplifier circuit to design an active first order low pass filter which passes frequencies that human can hear (below 15kHz). Show all the calculations required to find the values of all the passive comp..

  The carrier frequency

The output voltage of an AM transmitter is given by 500(1+.4sin3140t)sin6.28x107t. This voltage is fed to a load of 800 ohms. Determine the following. The carrier frequency The modulating frequency

  Write down the standard expression for a voltage

Write down the standard expression for a voltage, of r.m.s. value 45 V, and frequency 1.5 kHz. Hence, calculate the instantaneous value, 38 s after the waveform passes through its zero value.

  Find the vemf when the rod is parallel with the x-axis

Suppose the z=0 plane carries a sheet current K=5. A/m x. Then a 1 m long rod exists above the current sheet and has velocity u. Find the Vemf when the rod is parallel with the x-axis, u= 2(m/s) y.

  Explain importance of price escalation in economic analysis

A loan of $2,000 is made at an interest rate of 7% when the inflation rate is 10% and paid in one installment after 1 year. Calculate the amount paid. What is the difference between this result and the result obtained if the inflation is ignored?

  Charge at both capacitors

If a capacitor of 15uF is connected in series with 30uF and this combination is kept connected to a voltage supply of 10V then what is the charge at both Capacitors?

  Write a program in a script file that creates a n-m matrix

The value of the element in the first column is the number of the row. The rest of the elements are equal to the sum of the element above them and the element to the left. When executed, the program asks the user to enter values for n and m.

  What is the range of phase shifts induced by the modulator

Make sure to mark significant points in your figure (amplitude, offset, time, etc.). How could a device be modified to work as an electro-optic phase modulator? If we apply signal V, what is the range of phase shifts induced by this modulator.

  Calculate the required motor power after it has reached rpm

A large reel of paper installed at the end of a paper machinehas a diameter of 1.8m, a length of 5.6m and a moment of inertia of4500 kg-m2. It is driven by a directly coupled,variable-speed DC motor turning at 120 rpm. The paper is kept undera con..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd