### What is the flow rate of the gas stream

Assignment Help Chemical Engineering
##### Reference no: EM131157166

A gas stream contains 18.0mole% hexane and the remainder nitrogen, the stream flows to a condenser, where its temperature is reduced and some of the hexane is liquefied. The hexane mole fraction in the gas stream leaving the condenser is 0.0500. Liquid hexane condensate in recovered at a rate of 1.50L/min.

(a) What is the flow rate of the gas stream leaving the condenser in mol/min?

(b) What percentage of the hexane entering the condenser is recovered as aliquid?

#### Membrane sequence and the water feed rate required

A reverse osmosis plant is to be designed to produce 50 kg/s of boiler feed water with less than 20 ppmw of NaCl starting from sea water that contains 3.5 wt% NaCl. The 40 m

#### What is the thermal efficiency of the cycle

The steam then expands, reversibly and adiabatically, to the initial temperature of 487.15 K (214°C). Finally, the steam is compressed in a mechanically reversible, isotherm

#### What is the saturation pressure of cyclohexane at 250 k

A vapor mixture of carbon dioxide/cyclohexane is to be separated by partial condensation in a vapor- liquid separator at 250 K so that carbon dioxide is received at a purity

#### Make a thermodynamic analysis of this process

If the higher-pressure steam expands in a turbine of 78% efficiency and the lowerpressure steam is compressed in a machine of 75% efficiency. Make a thermodynamic analysis o

#### What is monetary value of information from a consumer survey

What is the monetary value of the information from a consumer survey to the venture capital company in this case? (ie what is the maximum that they should spend on a consume

#### Processes exothermic or endothermic

Are the following processes exothermic or endothermic? after selecting the answer please explain why you selected it. a. When solid KBr is dissolved in water, the solution g

#### Set up a table for a 4-to-10 line excess-3 decoding

Each combination is found by adding 3 to the decimal number being coded and translating the result into direct binary form. Set up a table for the excess-3 code for the 10 d

#### Estimate the maximum coefficient of performance

Design a vapor compression cycle using ammonia as the refrigerant that will be used to maintain the temperature of a stream at - 20 °C. The evaporator is air cooled and the