What is the correspoding carrier- to - noise ratio

Assignment Help Electrical Engineering
Reference no: EM13225994

An AM receiver, operating with a sinusoidal modulating signal and 80 percent modulation, has an output signal-to-noise ratio of 30 dB.

a) What is the correspoding carrier- to - noise ratio?

b) By how many decibels can we decrease the carrier- to- noise ratio so that the system is operating just above the threshold?

Reference no: EM13225994

Questions Cloud

Compute the hear of formation of b2o3 : When 1.00 g of Boron is burned in O2 (g) to form B2O3 (s), enough heat is generated to raise the temp of 733 g of water from 18.0 deg C to 38.0 deg C. Calculate the hear of formation of B2O3(s) under these condtions.
Compute a seasonalized or adjusted sales forecast : Season indices for the four quarters have been found to be 1.30, 0.90, 0.70, and 1.10 respectively. Compute a seasonalized or adjusted sales forecast.
How many decibels is system inferior to dsb- sc modulation : The average noise power per unit bandwidth measured at the front end of an AM receiver is 10^(-3) watt per Hertz. The modulating wave is sinusoidal, with a carrier power of 80 kilowatts, and a sideband power of 10 kilowatts per sideband.
Explain what was the mass percentage of the chloride : An excess of aqueous silver nitrate, AgNO3 was added to precipitate the bromide ion as silver bromide. If 8.00g of the soluble salt produced 2.00g of silver bromide, what was the mass percentage of the chloride in the sample?
What is the correspoding carrier- to - noise ratio : An AM receiver, operating with a sinusoidal modulating signal and 80 percent modulation, has an output signal-to-noise ratio of 30 dB. a) What is the correspoding carrier- to - noise ratio
Human population-atmospheric pollution-water resources : If you were an environmental researcher and were given funding to assist with one environmental issue, which of the following topics would you choose to spend your funds on?
What source screening activities are available to a supply : What source screening activities are available to a supply manager for critical procurements? Describe each one.
What two issues should be addressed in qualifying potential : What two issues should be addressed in qualifying potential international suppliers? Why?
Explain amitriptyline and nortriptyline over the toxic dose : why was nortripyline measured here? was there post-mortem redistribution? Explain.Were amitriptyline and nortriptyline over the toxic dose? Acute overdose/rapid death or chronic administration/show death? Explain

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Create a logic truth table for the logic equation

Signal Definitions are A.H, B.L ,C.L, D.H and Z.L. It is recommended you apply DeMorgan's Theorem first to the above equation. Draw (on paper) a circuit diagram implementing Z, using the minimum number of gates.

  What is the cross price elasticity of demand

What is the cross price elasticity of demand between XYZ's and AB C's widgets?

  Explain deploy a wireless telephone system

You have a bandwidth of 10 MHz (per direction) in a single-cell system and want to deploy a wireless telephone system. You have the following options: analog 30-kHz channels (as in AMPS)

  What is the conversion efficiency of an amplifier

What is the conversion efficiency of an amplifier in which the effective value of the current through a 2.2-k? load is 5 mA and the drain on the 18-V dc supply is 3.8 mA

  How many joules of energy are stored in the battery

A double-A (AA) rechargeable battery is rated at 1.2V, 2100mAh (mili-amp hours) 1- how many coulombs of charge can this battery hold 2- how many joules of energy are stored in the battery

  Define filter has steadily increasing attenuation

A filter has the following characteristics: Attenuation is 0 dB from 0 Hz to 2.5 kHz. Phase angle decreases linearly with increasing frequency above 2.5 kHz. Above 5 kHz the filter has steadily increasing attenuation.

  Calculate the current passing through the capacitors

First you must give all different possible connection types for them and then, for each case, you should develop some tests that can define the connection type and calculate the current passing through the capacitors.

  Explain the physical meaning of z transform

Please list the properties of Discrete Fourier Transform. Explain each property with an example to show what it means physically and explain the physical meaning of Z Transform

  Calculate the minimum value of vd

Calculate the minimum value of Vd if the power flow through the converter is 5 kW (a) from the ac to the dc side and (b) from the dc to the ac side.

  What is the op-amps open loop bandwidth

the upper critical frequency of anop-amps open loop response is 200Hz. If the midrange gain is 175,00, what is the ideal gain at 200Hz? what is th actual gain? what is the op-amps open loop bandwidth?

  How long a 1 inch square bar of copper have resistance

Using coppers resistivity of 10.30 CM-olm/ft at +25 °C, find how long a 1 inch square bar of copper would need be to have a resistance of 1 at +20 °C

  Define the reliability of a certain automatic cutoff device

The reliability of a certain automatic cutoff device is assumed 11/12. What is the reliability of a system consisting of 4 such devices so arranged

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd