What is the coe for a turbine with the following assumptions

Assignment Help Mechanical Engineering
Reference no: EM131231600

(a) What is the COE for a turbine with the following assumptions:

5 MW rating

31% capacity factor

$1250/kW turbine cost

$91,000 operations and maintenance cost/year

Fixed charge rate of 9%

BOS costs of $1,999,999

Levelized replacement costs of $135,000/year

(b) If a gearbox replacement was required every 5 years at a cost of $600,000, what would the COE be? How much (in percent) does the COE increase due to the gearbox replacement?

Reference no: EM131231600

Questions Cloud

State employment regulations apply to the employer : Which of the many federal and state employment regulations apply to the employer? Under the applicable laws, what are the employer's responsibilities to the employees? Please be sure to address each category of employee in your response. How would yo..
What is the corresponding yield of oat residue in tonnes : Wisconsin produced 13,260,000 bushels (25.4 kg per bushel) of oats on 195,000 ac (4046.85 m2 per acre) of land. What is the corresponding yield of oat residue in tonnes per km2 assuming a residue to grain ratio of 2:1?
Calculate the weighted cost of capital for southern company : Calculate the weighted cost of capital for The Southern Company. Estimate the fair market value (NPV) of SKS today. Assume that after 2020, EBIT will remain constant at $6030 million (no growth).
What are possible strengths of this approach : How could this method be used with your study question? Describe in 2-3 sentences how you could create a study with this design. What are possible strengths of this approach? What are limitations of this approach?
What is the coe for a turbine with the following assumptions : If a gearbox replacement was required every 5 years at a cost of $600,000, what would the COE be? How much (in percent) does the COE increase due to the gearbox replacement?
Transaction costs influence need for vertical integration : Why would an organization seeking to expand through diversification succeed more often by entering similar business? How do transaction costs influence the need for vertical integration?
What is the expected power output at a wind speed : A residential size WT has a diameter of 1 meter. Due to the size, its efficiency is only 25% of the Betz limit. What is the expected power output at a wind speed of 20 miles per hour? Assume the air density is 1.225 kg/m3.
Why do organizations repeatedly use growth as key strategy : Why do organizations repeatedly use growth as a key strategy? What are the benefits and challenges of growing through internal expansion? Acquisition? Networks and alliances? What are the main differences between upstream and downstream vertical st..
Calculate the block co-efficient : Using these dimensions and in anticipation of preparing the statutory "Stability" information/booklet calculate the following, explaining to your client the reason and significance of these numbers. the block co-efficient and the prismatic co-effic..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Calculate the convective heat transfer loss to the air from

a square aluminum plate 5 mm thick and 200 mm on a side is heated while vertically suspended in quiescent air at 40c. a

  A tugboat tows a ship at a constant velocity the tow

a tugboat tows a ship at a constant velocity. the tow harness consists of a single tow cable attached to the tugboat at

  The room is 3 m x 4 m x 26 meters high if we treat the room

0.25 kg of red-hot 700 c coals are taken from the fireplace and left in the middle of a room. the room is 3 m x 4 m x

  A steady flow of 15 kgs of high-pressure liquid oil drives

a steady flow of 15 kgs of high-pressure liquid oil drives a hydraulic motor at the steady-state-steady-flow conditions

  What is the magnitude of the torque

If the maximum rotation angle at the free end of the shaft must be limited to ∅C ≤ 3?, what is the magnitude of the torque TA that can be applied to A

  Explain whether this pressure cooker is operating under

a 4 l volume of pressure cooker in a kitchen operates at 200 kpa with an exit area of 10 mm2. with well controlled heat

  Find the velocity and kinetic energy

The movement of a particular piston of mass 0.25kg may be modelled with SMH. The acceleration is 12m/s when 8cm from the mid position. Find the period of the motion. If the amplitude is 11cm, find the velocity and kinetic energy

  A piston and cylinder machine containing a fluid system has

a piston and cylinder machine containing a fluid system has a stirring device in the cylinder the piston is

  Determine whether the cycle operates reversibly

A thermodynamic cycle operates between hot and cold reservoirs at 1120 K and 540 K, respectively, while receiving energy via heat transfer from the hot reservoir at a rate of 1620 kW.

  In 2001 the united states produced 51 of its electricity in

in 2001 the united states produced 51 of its electricity in the amount of 1.878 1012 kwh from coal fired power plants.

  It does this with air entering at 70 ms 500 c and 3 atm and

an air turbine is a continuous flow device that produces shaft power by expanding high pressure air. a particular air

  A manometer attached to the cylinder indicates a pressure

a vessel of cylindrical shape is 50 cm in diameter and 75 cm high. it contains 4 kg of a gas. a manometer attached to

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd