What is the bulk densityof a box filled with 88 marbles

Assignment Help Civil Engineering
Reference no: EM13326429

What is the bulk densityof a box filled with 88 marbles, each of which weighs 1/2 oz, wherethe box weighs 9 oz and has interior measurements of 4" x 5" x10"?

Reference no: EM13326429

Questions Cloud

Find what is the velocity m per s in the upstream pipe : A pressure gage connected between the upstream pipe and throat section shows a pressure difference of 29 kPa. The gasoline velocity in the throat section is 14 m/s. What is the velocity (m/s) in the upstream pipe
Analyze the cycle from 1st and 2nd thermodynamics point view : A proposed combined cycle power plant is shown below. A gas turbine engine, the topping cycle, takes air at state 1 (T=300 K, P=100 kPa) and compress it irreversibly (hc=0.87) to state 2.
Determine the volume-temperature and pressure at all state : Air enters an air - standard Otto cycle with a pressure and temperature of 1 bar and 15 C respectively. The compression ratio is 9 and the bore and stroke of the cylinder are (10 cm, 12 cm).
What is the weight density of the mortar sample : A sample of mortar fills a900 ml beaker. The mortar and beaker combined weighs 3 lb and theempty beaker weighs 2 oz. What is the weight density of this mortar sample
What is the bulk densityof a box filled with 88 marbles : What is the bulk densityof a box filled with 88 marbles, each of which weighs 1/2 oz, wherethe box weighs 9 oz and has interior measurements of 4" x 5" x10"
What is the maximum miles down the track for a siding : Freight train A passes through Petticoat Junction, a node where twosingle track lines connect, at 6:50 AM, traveling at 40 MPH, with50 cars that are 70 feet nose to nose. A faster train B jumps ontothe same track at the junction at 9:20 AM.
What the workplace 2020 organization will look like : State why your Workplace 2020 organization does or does not conform with the organizational design trends discussed in this chapter.
Explain is the beam adequate to support the load : A W16 x 36 simply supported beam is 30 ft long and supports auniform dead load of 970 lb/ft, a roof live load of 240 lb/ft and asnow load of 270 lb/ft. Is this beam adequate to support the load
How many bins can the manufacturer now produce : Suppose that the costs are expected to go up to $6 per squarefoot (base) and $4 per square foot (sides), by the end of theyear.How many bins can the manufacturer now produce if she stillwishes to minimze material costs

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the volume flow rate of water

Water with a static pressure of 1.96kN/M 2 flows through an 800 mm diameter pipe. A pitot tube pressure gage in this pipe reads a pressure of 5.88 kN/M 2 . How do you determine the volume flow rate (Q) of the water? (Q = 1.40 M^3/sec, V=2.79 M/se..

  Calculate distance downwind xl at which the plume released

A powerplant is burning coal on a cold, clear winter morning at 8am with a wind speed of 2.6m/s measure at 30m and an inversion layer with its base height of 697m. The effective stack height is 30m.

  What is the distiniction b/n point and non point sources

what is the distiniction b/n point and non point sources of water pollution and thier varation with surface and ground water?

  Determine what is the permeability of the soil

The Permeability of a semi-impervious soil was evaluated in a falling-head permeameter whose head decreased from 40 to 15 inches in 5min. The body diameter was 0.1 inch, and the sample length and diameter was 2 inches.

  Determine the required dimensions of a hollow steel shaft

Determine the required dimensions. The inside diameter is to be two- thirds of the outside diameter. The allowable shearing stress is 70 MPa, and the angle of twist is not to exceed 4 degree in 3 m of the shaft.

  Design the ramp for the highest horizontal curve

The entrance to Mt. Hood Meadows (elevation 3,075 ft at the point of crossing) is grade separated from Viking highway (elevation 3,050 ft at the point of crossing) and will have to be connected. The two roadways intersect at a right angle.

  How much will be the contribution in the funds in 20 years

You are paying into a mututal fund that earns 6% compound interest. If you are making an annual contribution of $10000, how much will be in the funds in 20 years What if the fund makes 10% What if it loses 5% per year

  Calculate what is the surface area of the disk rotor

During frequent braking under race conditions the disk brake rotors on the car described above reach a temperature of 500C. These disk brakes rely on forced convection to cool them.

  Find min acceptable wire diameter for max allowable stress

A 200ft length of steel wire is to carry a tensile load of 340lb. Find the minimum acceptable wire diameter if the maximum allowable stress in the wire is 30ksi, and the lengh of the wire must not increase by more than 2 inches when there is no ch..

  Would recycle of return sludge increase the sludge age

if the sludge concentration in the return sludge line from the secondary clarifier were the same as the MLVSS concentration.WOULD recycle of return sludge increase the sludge age why

  Determine the moment of the l6-n force about point b

A foot valve for a pneumatic systemis hinged at B. Knowing that a=28degrees, determine the moment of the l6-N force about point B by resolving the force into horizontal and vertical components

  Why covalently bonded materials are generally less dense

Offer an explanation as to why covalently bonded materials are generally less dense than ionically or metallically bonded ones.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd