What is the binary value on the a-d output pins

Assignment Help Electrical Engineering
Reference no: EM13228147

An 8-bit A/D converter has Vref- = 2 V and Vref+ = 5 V. The analog input signal vin has a frequency range of 300 Hz to 3.4 kHz.

a) If vin = 7 V, what is the binary value on the A/D output pins?

b) If vin = 1 V, what is the binary value on the A/D output pins?

c) If vin = 3.3 V, what is the binary value on the A/D output pins?

d) Explain why the binary output value should never be allowed to fall below 0000 0001.

e) What is the minimum sampling rate of the A/D converter to get an accurate digital version of the analog signal?

Reference no: EM13228147

Questions Cloud

Write formula for the magnetization volume current density : Write the formula for the magnetization volume current density J M and magnetization surface current density JMS in terms of magnetization vector M. 4. A sphere has permanent magnetization where is a positive constant.
State what is its molar mass : A sample of a gas weighs 2.006 g and has a volume of 1060.0 mL at 795.0 torr and 32.0 degrees Celsius. What is its molar mass?
State what is the partial pressure of co : A mixture of 0.146 moles of C is reacted with 0.117 moles of O2 in a sealed, 10.0L vessel at 500 K, producing a mixture of CO and CO2. The total pressure is 0.640 atm. What is the partial pressure of CO?
Find the speed of the sphere after the acceleration : The charge is release from rest and accelerate through a potential difference of 100000v. (a) Find the speed of the sphere after the acceleration. (b) if the sphere (which is already up to its max)is fired directly at a fixed (can't move) charge q..
What is the binary value on the a-d output pins : An 8-bit A/D converter has Vref- = 2 V and Vref+ = 5 V. The analog input signal vin has a frequency range of 300 Hz to 3.4 kHz. a) If vin = 7 V, what is the binary value on the A/D output pins b) If vin = 1 V, what is the binary value on the A/D outp..
What might be an example of an input and an output : (1) What might be an example of an input and an output What are some simple examples of what constitutes the distinction between input into a program and output from the program (2) What type of arithmetic operations are supported in C++
Explain concentration is required to precipitate : If the concentration of Mg2+ ion in seawater is 1350 mg/L, what OH- concentration is required to precipitate Mg(OH)2
Compute the concentrations of the nonionized acid : Calculate the concentrations of the nonionized acid (HA) and of the ions of a 0.100 M formic acid (HCO2H) solution at equilibrium, and calculate % ionization.
Compute the work in joules when water vaporizes : Calculate the work in Joules when 2.5 mols of water vaporizes at 1 atmosphere pressure and 25 degrees C. The work is done in pushing back the atmosphere.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What were the repercussions

Tell us about a time when you failed to meet a deadline. What were the repercussions?

  Determine where the poles and zeroes of the system

The transfer function of a circuit is given by H(s)=2 s+4/4s^2+2s+2 a. Express the transfer function in a form in which the coefficients of the highest power of s are unity in both numerator and denominator. b. What is the characteristic equation o..

  What is the angle at each tip of the cottage

The cross section of a cottage 20 ft wide is an isosceles triangle. If the slope of a side is 1.75 and there is a second floor 9 feet above the ground floor,What is the angle at each tip of the cottage?

  Calculate the rated armature current

A 240kW 500V 1750 r/min separately excited dc generator has an overall efiiciency of 94%. The shunt field resistance is 60 ohms and the rated current is 5A. The I^2 R loss in the armature is 0.023 pu.

  Explain telephone channels and pcm analysis

Telephone channels and PCM analysis, The analog to digital converter (ADC) used in a telephone system outputs 8 bit words. The digital words are transmitted as a serial stream to form a PCM voice signal

  Write down the principle of energy conversion

Write down the principle of energy conversion and give an example for single and double excited system.

  Find the output frequency when the input frequency

A system samples a sinusoid of frequency 480 Hz at a rate of 100 Hz and writes the sampled signal to its output without further modification. Determine the frequency that the sampling system will generate in its output.

  Calculate the total apparent power supplied by the source

A three-phase transmission line having a reactance of 120 ohms per phase is connected to a wye-connected load whose resistance is 160 ohms per phase. If the supply volatge is 70kV line-to-line, calculate a) The line-to-neutral voltage per phase.

  Calculate pmos device to acheive symmetric propagation delay

Calculate the PMOS device with to acheive symmetric propagation delays in an inverter (tPLH = tPHL). Use Wn=450nm Ln =300nm and Lp=300nm and solve for Wp. So I think by some ratio I can find what Wp should be, maybe something like Wn/Ln=Wn/Lp

  Write a program to genrate a square wave

assuming XTAL=11.0592 MHz,write a program to genrate a square wave of 20 Hz frequency on pin2.3?

  Rate at which succesful packets arrive at network node

Rate at which succesful packets arrive at network node, After traversing a wireless filled channel packets arrive at a networks node according to a Poisson process with rate Lambda

  Determine the noise on the output as percent fs

A system is needed to measure flow, which continuously cycles between 20 and 30 gal/min with a period of 30 sec. The required output is a voltage varying from -2.5 to +2.5 V for the cycling flow range. The sensor to be used has a transfer function..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd