Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A car is traveling toward a 20 degree slope at 60 mph. The wheels have a radius of 12 in, and the car's wheelbase is 100 in. What is the angular rotation rate of the car immediately after the front wheel contacts the slope? Assume that A, the center of the rear wheel, continues to move horizontally at 60 mph.
A town is going to upgrade its primary WWTP to a secondary plant that can meet the effluent standard of 25 mg/L BOD5 and 30 mg/L suspended solids. They have selected a CSTR activated sludge system for the upgrade.
vehicle manufacturer is considering an engine for a new sedan (Cd=0.34, Af=22ft^2). the car is being designed to achieve a top speed of 100 mi/h on a paved surface at sea level (p=0.002378 slugs/ft^3).
A train 552 m long is moving on a straight track with a speed of 88.5 km/h. The engineer applies the brakes at a crossing, and later the last car passes the crossing with a speed of 13.7 km/h.
disk of radius R=7 in. spins at a constant angular speed of w=500rpm in the clockwise direction. If the disk is released from rest far above the ground, what are the speed and acceleration of the disk's top C point after it has fallen h=3ft
A simply supported steel 'I beam' is made of three 1"*8" plates with a mass of 898.4 lbmass each as shown in I beam form. Steel has a modulus of elasticity of 30*10^6 psi. The beam is allowed to deflect 1.05 inch.
A sample of natural glacial till was taken from below the groundwater table. The water content was found to be 52%. Estimate the wet density,dry density,buoyant density,porosity,and void ratio. Clearly state any necessary assumptions.
The boiling water passes through copper pipes that have a wall thickness of 4 millimeters and a surface area of 0.12 square meters per meter length of the pipe. Find the total length of pipe (there are actually many pipes in parallel)
Each week 85 trucks bring a total of 2,180 metric tons of municipal solid waste (MSW) to the landfill. Each truck averages two loads per day. Each truck has a capacity of 4.5 metric tons and they operate 5 days/week.
Reciprocal leveling gives the following readings in feet from a setup near A: on A, 2.071; on B, 8.254, 8.259 and 8.257. At the setup near B: on B, 9.112; on A, 2.926, 2.930 and 2.927. The elevation of B is 1099.600. Compute the disclosure and ele..
a bearing wall carries a dead load of 120kn/m and live load of 100 kn/m. It is to be supported on a 400mm deep continuous footing underlain by a medium sand (unit weight = 19.2 kn/m3, phi= 37 deg, effective c = 0).
The frame is supported in part by normal and friction forces between the wall and the plate at A. Determine the friction force exerted on the plate at A. Also determine the minimum required coefficient of friction at A for the frame to remain in e..
Given an 18-in. concrete conduit with a roughness coefficient of n = 0.013, s = 0.02, and a discharge capacity of 15 cfs, what diameter pipe is required to triple the capacity?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd