Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The work-piece motion of a certain system is measured using an LVDT that outputs 12mV/cm.
(i) If the output from the LVDT ranges from -12mV to 24mV, what is the maximum horizontal motion of the work-piece motion?
(ii) Assuming a linearity of ±0.25% over the whole range, what is the displacement range that could be interpreted from a 10mV measured voltage?
Two transistors, fabricated with the same technology but having different junction areas, when operated at a base-emitter voltage of 0.72 V, have collector currents of 0.2 mA and 12 mA. Find Is for each device.
What are two of the major considerations that factor in the design of a substation. Give a couple of examples of station layouts where these factors are clearly demonstrated. What typical grounding materials are used in substations.
For each one of the 3 frequency responses, H(f), in parts (a), (b), and (c) do the following: i. Obtain the system's impulse response, h(t). ii. Indicate if the system is BIBO stable or not, and state why. iii. Indicate if the system is causal or not..
A point source of light is 12 cm below the surface of a large body of water (n=1.33 for water). What is the radius of the largest circle on the water surface through which the light can emerge
Signal transduction refers to any process of changing one signal to signal of another type. An example would be a series of pulsing lights into the sound for the word: "Help". Discuss how this transduction could be done by a device.
Two three-phase loads are y-connected across a 300 Volt three phase line. One load draws 10kW at a p.f. of 0.9 leading, and the second load draws 8kW at a p.f. of 0.6 lagging. V(line-neutral)=300V/sqrt(3)=173.21V
An Australian emu is running due north in a straight line at a speed of 13.0 m/s and slows down to a speed of 10.5 m/s in 3.60 s. (a) What is the magnitude and direction of the bird's acceleration
A 2.4KV, single-phase circuit suppllies a load of 250KW at a lagging power factor, and the load current is 160A. If it is necessary to improve the power factor, determine the following: (a)The uncorrected poer factor and reactive load.
Draw the logic diagram for the 4-bit circuit, using full adders and multiplexers. Determine the arithmetic operation performed for each of the four combinations of S and Cin: 00, 01, 10, and 11.
The parts of this problem refer to the reflection method of solving real transformer problems: A.What is the value of Zload projected into bus (Region) 2 B.What is the total impedance of bus 2 including the projection
The EPROM should be mapped in a single block starting at address 0000 hex and the RAM should be mapped in a single block starting at address 8000 hex. 8051: Hardvard architecture with separate control busses for code and data memory.
The anode of the diode is connected to the inverting node of the op-amp, while its cathode is connected to the output of the op-amp. Determine the expression of the output node potential as a function of the input node potential.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd