What is maximum acceleration from rest for car with engine

Assignment Help Civil Engineering
Reference no: EM13307003

A newly designed car has a 9.0-ft wheelbase, is rear-wheel drive, and has a center of gravity 18 inches above the road and 4.3 feet behind the front axle. The car weights 2450 lb, the mechanical efficiency of the drivetrain is 90%, and the wheel radius is 14 inches. The base engine develops 200 ft-lb of torque, and a modified version of the engine develops 240 ft-lb of torque. If the overall gear reduction ratio is 8 to 1, what is the maximum acceleration from rest (in ft/sec^2) for:

a) the car with the base engine?

b) car with the modified engine?

Assume the car is on good dry pavement.

Reference no: EM13307003

Questions Cloud

The crate is sliding down the ramp : 1)A crate of potatoes of mass 19.0 kg is on a ramp with angle of incline 30° to the horizontal. The coefficients of friction are μs = 0.82 and μk = 0.29. Find the frictional force (magnitude and direction) on the crate if the crate is sliding d..
Find how much time passes before the ice starts to melt : An open container holds ice of mass 0.595kg at a temperature of -13.5 celcius . The mass of the container can be ignored. How much time passes before the ice starts to melt
What is total delay for cycle for the saturation flow rate : A signal approach has 20 seconds of displayed green, 4 seconds of yellow, and 3 seconds of all red (assume typical start-up, lost time, and clearance time). The cycle length is 60 seconds.
The crate is sliding up the ramp : A crate of potatoes of mass 8.0 kg is on a ramp with angle of incline 30° to the horizontal. The coefficients of friction are μs = 0.72 and μk = 0.43. Find the frictional force (magnitude and direction) on the crate if the crate is sliding up t..
What is maximum acceleration from rest for car with engine : The car weights 2450 lb, the mechanical efficiency of the drivetrain is 90%, and the wheel radius is 14 inches. The base engine develops 200 ft-lb of torque, and a modified version of the engine develops 240 ft-lb of torque.
Compute the thickness of the glass : A very thin sheet of glass (n=1.5) floats on the surface of water (n=1.33). When illuminated with white light at normal incidence, What is the thickness of the glass
What is the speed of the combined masses after collision : An iron bar of mass, 0.55 kg, slides down a frictionless incline 0.41 m high. What is the speed of the combined masses after collision
Determine heat loss from steam passing through turbine : Steam enters a turbine with neglible velocity at 4 mpa, 600 degrees celcius and a flow rate of 36000 kg/h. Determine the heat loss from the steam passing through the turbine if the turbine has a power output of 20000 kw
Find how far is this point horizontally from the end of ramp : A skateboarder shoots off a ramp with a velocity of 6.9 m/s, directed at an angle of 56 ° above the horizontal. The end of the ramp is 1.1 m above the ground. how far is this point horizontally from the end of the ramp

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Determine the stations and elevations of pvcs and pvis

Using a design speed of 50 mi/h, determine the stations and elevations of PVCs, PVIs, and PVTs of the two vertical curves required to connect the highway segments, as well as the length of the constant grade section (connecting grade is to be as s..

  Fraction of the herbicide

The herbicide 2,4,D, is applied to a golf course at a rate of 1.2 kg/ha. The organic matter content of the soil is 1%, bulk density is 1.3 g/cm3, and water content is 0.3. a) What fraction of the herbicide is adsorbed, and what fraction is dissolve..

  Calculate how much energy must be added to the system

A piston-cylinder contains 40 kg water of which 20 kg is saturated liquid. The equilibrium pressure of the system is 100 kPa. a) Find the system initial volume b) The water undergoes an isothermal expansion until the pressure reaches 10 kPa.

  Determine how much runoff reached the river for the year

The average rate of flow measured in a gage at the outlet of the watershed was 30 m^3/sec. Estimate the water losses due to the combined effects of evaporation, transpiration, and infiltration due to ground water.

  Find area of steel reinforcement required for concrete tbeam

Find the area of steel reinforcement required for a concrete T-beam for the following data; f'c = 3 ksi, fy=60 ksi,d=18 in, t= 4.5 in., bw= 10 in., bf= 36 in., 3/4" aggregate, and the section sustains a total factored bending moment 82 k-ft.

  Determine probabilities of different events of flood wall

A temporary flood wall has been constructed to protect several homes in the floodplain. the wall was built to withstand any discharge up to the 20-year period after all the homes have been relocated.

  What is the average annual inflation rate for the machine

You purchased a machine 5 years ago for $100,000 and now the machine costs $135,000. What is the average annual inflation rate for this machine

  Determine the magnitude of force p to produce

A thin-walled cylindrical tank of radius r is subjected simultaneously to internal pressure p and a compressive force P through rigid end plates. Determine the magnitude of force P to produce pure shear in the cylindrical wall.

  Determine the degree of saturation-void ratio and porosity

After drying in the oven, it weighs 4.44 kg. The relative density of the grains is 2.70. Determine the degree of saturation, void ratio, porosity and moisture content of the soil in its natural state.

  Determine the angular acceleration of the spool

determine the angular acceleration of the spool and the acceleration of the trailer. The wheels have negligible mass and are free to rotate.

  How to determine the scale reading at t

A large tank is used to calibrate the reading from a flow meter. Measurements of the system weight as a function of time are made. Water enters the tank vertically from the flow metering system at a speed of 20 ft/sec through a 1.5 in.

  At what flow rate should the farmer pump the water

A farmer wants to irrigate a piece of land in 15 hrs. The area of the field is 15 acres. the farmer grows alfalfa that requires 3.5 inches of water during the 15 hours.At what flow rate should the farmer pump the water

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd