Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
What fundamental property is used to transmit information through a channel?
Consider a telephone line with a channel bandwidth of 2 kHz and SNR of 40 dB. What is the maximum data rate possible?
A 10-µF capacitor is charged to a potential of 100V. At time zero it is discharged through a 1-M ohm resistor. What is the time constant for this system
Consider a MOS device with the following parameters: Aluminum gate, p- type silicon substrate, oxide thickness of 20nm, and surface fixed oxide charge of 4x1010 cm-2 (a) Determine the doping concentration such that the threshold voltage is 0.5V.
Sehat Sutardjareceived a Ph.D. in 1988 from Berkeley from one of the most distinguishedprofessors in the electronics field. He published apaper in the IEEE Journal of Solid State Circuits in December of that year.
An abc-phase-sequence three phase voltage source connected in abalanced wye supplies power to a balanced delta-connected load. Theload current Iab = 4
Two hanging balls, each with a mass of 10g, have equal charges. One ball is hung by an insulated thread. Another ball held by an insulated rod.
If vid is 20-mV peak-to-peak sine wave applied in a balanced manner but superimposed on VCM = 0.5 V, what is the value that VDD must have to ensure saturation-mode operation for Q1 and Q2 at all times. Assume Vt = 0.5 V.
a signal franging from 1khz to 100khz will be put into a davice that will need amplification that will output to speakers. A 12v battery is available as a power source, however the current out of the battery should be kept to a minimum.
Two amplifiers are cascaded, one with a voltage gain of 6.02 db and the other with a voltage gain of 12. If 10 mV is measured at the input of the second amplifier, what is the voltage at the input of the first amplifier
Use a frequency analysis PSpice to plot the frequency response o the transfer function magnitude s indicated Plot at least one decade above and below an corner frequency
The integer array and the size of the array are passed into the function through parameters. Do not worry about includes. This is only a function, so there is no main routine. The function should fill the array with valid inputs.
An amplifier without feedback is having a voltage gain of 80 and a current gain of 100 and an input resistance of 600-ohm. Find out the input resistance offered when voltage series feedback is employed with a feedback factor of 5%.
1.)An op amp requires the design equation Vout = 5Vin & 2Vref + AgVg. What is the value of Ag 2.)The voltage dropout of a voltage regulator is 1.6 V. If a 16 V output is required, what is the minimum regulator input voltage
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd